Vimar PIXEL UP 40405 Manual De Instalación Y Cableado página 5

PIXEL UP: 40405
Rear view
Due Fili Plus
audio video unit
41005UP
Interface module
41030UP
Display
41018UP
Alphanumeric
keyboard
41019UP
Terminal block for connection tot he audio/video unit
Terminal functions
B2
Due Fili Bus
B1
E+ Additional external power supply, from power supply unit
6923 (output +U).
E-
CA+ Lock control additional button (Default).
Alternatively (if configured via SaveProg), sensor input
CA-
to signal "Door Open".
Electric lock output
S+
Note: S+/S- outputs. The entrance panel supplies a
current peak I T >1A for 10ms after which there follows a
maintenance current I M =200mA for the entire duration of
S-
the lock command (see lock time).
Terminal block for connection to display
Terminal functions
Input programmable using configuration
CA-
software (e.g. lock release command, door
open signal sensor, command of actuator
available in system). Note: connect to an
CA+
isolated SELV voltage free-contact.
Terminal block for connection to keyboard
Terminal functions
NO
Relay output with NO and NC contacts cho-
sen by the installer.
The contact can control resistive loads exter-
C
OUT1
nally powered with maximum current 1 A and
maximum voltage 60 Vdc (maximum voltage
NC
permitted by 60950-1 for the SELV).
Relay output with NO and NC contacts cho-
NO
sen by the installer.
The contact can control resistive loads exter-
OUT2
C
nally powered with maximum current 1 A and
maximum voltage 60 Vdc (maximum voltage
NC
permitted by 60950-1 for the SELV).
EN
5