Information
In Case of Difficulty
If you encounter a problem, please review the items in
the following checklist. This guide will help you isolate
the problem if the unit is at fault. Otherwise, make sure
the rest of your system is properly connected or consult
your authorized Alpine dealer.
No function or display.
• Car's ignition is off.
- Turn the ignition on.
• No fuse or blown fuse.
- Check the cause and replace the fuse.
• Incorrect connections.
- Check connection and remedy.
• Vehicle's battery is weak.
- Check the voltage of vehicle's battery.
No picture display.
• Brightness control is set for minimum brightness control.
- Adjust the brightness.
• Incorrect setting of the VTR mode.
- Switch to the correct mode.
• Protective circuit is on because of high temperature.
- Wait until the temperature inside the vehicle comes
down to the operating temperature range (45°C).
• Incorrect or open connection with the Monitor, AV
interface unit.
- Check the connection and remedy.
Picture color is poor.
• Brightness/Color/Tint control are not set to the proper
positions.
- Check each control.
Spots or dotted lines/stripes appear.
• Caused by neon signs, high-voltage power lines, CB
transmitter, other vehicle's ignition plugs, etc.
- Change the location of your vehicle.
Unit does not operate.
• Monitor's power is not turned on.
- Turn on the monitor's power.
- E N
Information
Specifications
MONITOR
Screen Size
Display System
Drive System
Number of Picture Elements
Effective Number of Picture Elements 99.99% or more
Light Source
Dimensions (W x H x D)
Weight
Black box
Dimensions (W x H x D)
Weight
• Due to continuous product improvement,
specifications and design are subject to change
without notice.
• The LCD panel is manufactured using an extremely
high precision manufacturing technology. Its
effective pixel ratio is over 99.99%. This means that
there is a possibility that 0.01% of the pixels could
be either always ON or OFF.
7.0-type
Low reflection rear
projection type TN liquid
crystal panel
Active matrix drive,
normally white display
800(W) x 480(H) x 3
1,152M pixels (VGA)
Internal optical system
(U-type cold cathode
fluorescent tube)
173 x 118.5 x 19.5mm
500g
177 x 103 x 28 mm
400g