Changing The Attached Tool; Place A Sanding Sheet On The Backing Plate; Bringing Into Use; Switching On / Off - Parkside PMFW 310 B1 Instrucciones De Utilización Y De Seguridad

B
HCS
Segment saw blade Z85 B3
Material:
Wood
Use:
· Cutting and plunge sawing
· Close to the edge sawing, even in difficult to
access areas
Example: Laying parquet and other floor coverings,
including plunge sawing. (see Figs. C, E and F)
Scraping knife Z52 A2
Materials: Mortar / concrete residues, tile / carpet
adhesives, paint / silicone residues
Use:
· Removal of material residues, for example tile
adhesive when replacing damaged tiles
(see Fig. I)

Changing the attached tool

Q
NoTE: If you would like to use the vacuum dust
extraction device, you must connect it before attach-
ing or changing the attachment (see section on
"Connecting a vacuum dust extraction device").
DANGER oF INJURY! Pull
the mains plug out of the mains socket
before you carry out any task on the
electrical power tool.
Assembly / Bringing into use / Maintenance and cleaning
8
9
R emove any tool already inserted. To do this,
release the clamping screw
key and take off the tool.
11
P lace the tool (e.g. plunge saw blade
the tool mount.
NoTE: You can place the tool in any of the
possible positions on the tool mount.
F asten the tool in place with the clamping
screw and clamping plate
10
clamping screw
10
C heck that the tool is firmly seated.
Incorrectly or insecurely attached tools could
become lose during use and injure you.
Place a sanding sheet
Q
on the backing plate
O ffer up the sanding sheet
one side of the backing plate
the sanding sheet to the backing plate.

Bringing into use

Q

Switching on / off

Q
S lide the ON / OFF switch
switch on the device.
S lide the ON / OFF switch
switch off the device.

Selecting the oscillation speed

Q
P reselect the required oscillation speed using
the oscillation speed setting wheel
NoTE: The required oscillation speed depends on
the material and the working conditions and can
be determined by means of a practical test.

Maintenance and cleaning

Q
DANGER oF INJURY! Pull
the mains plug out of the mains socket
before you carry out any task on the
electrical power tool.
using the Hex
10
) on
6
. Tighten the
4
using the Hex key .
11
to fit flushly on
12
, then apply
7
forwards to
1
backwards to
1
.
2
GB/MT 41