Assembly And Adjustment - Black and Decker GH900 Manual De Instrucciones

FUNCTIONAL DESCRIPTION (FIgURE A)
1. On/Off Trigger Switch
2. Cord Retainer
3. Power Cord Plug

ASSEMBLY AND ADJUSTMENT

WARNINg:
EDgE gUIDE OR HANDLE. NEvER OPERATE TOOL WITHOUT gUARD FIRMLY IN PLACE. THE
gUARD MUST ALWAYS BE ON THE TOOL TO PROTECT THE USER.
ATTACHINg THE gUARD
WARNINg:
• Turn the trimmer upside down so that you are looking down at the spool (9).
• Remove the screw from the guard with a phillips screwdriver.
• Turn the guard (8) upside down and slide it fully onto the motor housing (6). Make sure the
tabs (10) on the guard engage the ribs (11) on the motor housing as shown in figure B. The
locking tab (25) should have snapped into the housing slot (26).
• Continue to slide the guard on until you hear it "snap" into place.
• Insert the guard screw as shown in figure C to complete the guard assembly.
• Once the guard is installed, remove the covering from the line cut-off blade, located on the
edge of the guard.
ATTACHINg THE AUXILIARY HANDLE
• To attach the handle (4), press in on the buttons (12) on both sides of the upper housing as
shown in figure D.
• Position the handle as shown in figure E, matching up the grooved side of the handle with
the grooved button. Partially push the handle on so that it will hold the buttons in when you
release them with your hand.
• Push the handle completely onto the housing and position it slightly until it "snaps" into
place (figure F).
• To adjust the handle up or down, press in on the button (13) and raise or lower the handle.
• The handle should be adjusted so that your front arm is straight when the trimmer is in the
working position.
HEIgHT ADJUSTMENT
CAUTION:
Adjust the length of the trimmer to obtain proper working positions as shown
in figure I1.
• The overall height of the trimmer can be adjusted by loosening the collar (5) and rotating it
in the direction of the arrow shown in figure g.
• Move the upper housing straight up or down. When the desired height is achieved, tighten
the collar by rotating it opposite of the direction shown in figure g.
ATTACHINg EXTENSION CORD (FIgURE H)
• An extension cord retainer (2) is built into the switch handle that prevents the cord from
coming unplugged. To use this feature, simply double the extension cord about 8 inches
(203mm) from the end, and insert it into the slot (14) in the end of the handle area as shown
in figure H. Hook the loop formed by doubling the cord over the tab (2). Gently tug on the
cord to insure that it is firmly retained in the trimmer's handle. Plug the receptacle end of the
extension cord into the power cord plug (3) in the trimmer.
4. Auxillary Handle
5. Collar
6. Motor Housing
UNPLUg THE TRIMMER BEFORE ATTEMPTINg TO ATTACH THE gUARD,
NEvER OPERATE TRIMMER WITHOUT gUARD FIRMLY IN PLACE.
6
7. Edge Guide Wheel
8. Guard
9. Spool