120-240 Vac Models; Changing The Flash Pattern - Federal Signal Global Serie Instrucciones De Instalación Y Mantenimiento

c.
Connect the earth ground wire to the terminal block pole
marked

120-240 Vac Models

a.
See Figure 12 on page 18. Connect the line (hot) power
source wire to the terminal block screw marked
b. Connect the neutral (common) power source wire to the
terminal block pole marked
c.
Connect the earth ground wire to the terminal block pole
marked
3. Secure the cover on the terminal box with the four M4 screws.
Ensure that the gasket is p roperly seated to maintain the IP
rating. Do not overtighten the cover screws.
4.
Test the beacon for proper operation.

Changing the Flash Pattern

LIGHT HAZARD: To be an effective warning device, the beacon
produces bright light that can be hazardous to your eyesight
when viewed at close range. Do not stare directly into the light at
close range or permanent damage to your eyesight may occur.
EXPLOSION HAZARD: To prevent ignition of hazardous
atmosphere, disconnect the device from the supply circuit before
opening it. Do not open the device in the presence of explosive
gases in the atmosphere.
BURN HAZARD: The LED emitter gets hot enough to burn you.
Always allow the emitter to cool before handling it.
The Model G-LED Series beacon has eight flash patterns that are
selected by setting a DIP switch on the PCB. See Figures 13 and 14 on
page 21.
Model G-LED Global Series LED Beacon
Installation and Maintenance Instructions
.
.
.
L2/-
.
L1/+
19