Safety Messages For Wiring - Federal Signal Global Serie Instrucciones De Instalación Y Mantenimiento

Safety Messages for Wiring

When installing and operating flame-proof electrical equipment,
the relevant national regulations for installation and operation (e.g.,
EN60079-14, IEC Wiring Regulations and NEC/CEC) must be
observed.
• To maintain the flame-proof integrity of the enclosure, DO NOT
damage the LED lens cover or threads while disassembling or
reassembling unit.
• To avoid electrical shock hazards, do not connect wires when
power is applied. Failure to observe this warning may lead to
serious injury or death.
• Painting and surface finishes, other than those applied by Federal
Signal Corporation, are not permitted.
• Cable termination should be in accordance with specifications
applying to the application. Federal Signal recommends that all
cables and cores should be fully identified.
• Ensure that only the correct equipment-certified glands are used and
that the assembly is shrouded and correctly earthed. Gland entries
are M20-1.5 6H with an option for the M25 entry on the end of the
increased safety box models. See Table 3 on page 29 for choosing
correct cable entry devices for Equipment in Potentially Explosive
Atmospheres.
• Because of space limitations, ensure the cable cores within the
unit are not too slack.
• In all countries, the wiring must comply with all national and local
codes and standards.
• Ensure that all nuts, bolts, and fixings are secure.
Model G-LED Global Series LED Beacon
Installation and Maintenance Instructions
13