Preprogrammed Cycles - Alliance Laundry Systems UW35PV Instrucciones Se Operacion Y Programación De La Microcomputadora

2. Place both the simulator and the computer
in the PROGRAM mode. The display on
both will read "CYC00."
3. Press the 0 key. The display will read
"WRITE?"
4. Press the Enter key. The display will read
"ALL."
5. Press the 0 key. The display will read
"CYC00."
6. Press the Enter key. The display will read
"RCYC00."
Now press the 2-digit code for the desired
cycle number from the simulator.
7. Press the Enter key. The display will read
"WCYCcc."
Now press the 2-digit code for the desired
cycle number under which the cycle
should be saved in the computer.
8. Press the Enter key. The simulator display
will flash "SEND" and "CYC" alternately.
The computer display will flash "RECV"
and "CYC" alternately.
When the two displays stop flashing, the
transfer is complete.
F232089 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming

Preprogrammed Cycles

This section lists the 39 preprogrammed
(ready-to-use) cycles. To run a cycle, first
make certain that the computer is in the RUN
mode. Then enter the two-digit code for the
desired cycle, and press the Start key.
Test Cycle 01 (standard listing) is the first of
the 39 preprogrammed cycles. This cycle is
used to verify proper operation of the machine.
Any of these 39 cycles may be erased and
replaced by new cycles. As shown earlier in
this section of the manual, the cycles may also
be edited and revised to match a particular
application's specific needs. Thirty-seven of
the preprogrammed cycles use high speed spin
No. 3 (maximum G force) for the final extract.
The following prompts are set at the factory:
• Degrees F
• One drain
• Advance enabled
• Manual mode enabled
• Wet clean disabled
• "S BAL" or "L BAL," depending on AC
inverter drive model
57