Editing A Cycle - Alliance Laundry Systems UW35PV Instrucciones Se Operacion Y Programación De La Microcomputadora

Programming
Cycle Programming
The computer will remain in this step
until one of the following options has
been chosen:
• Press the Enter key to continue
displaying the cycle, OR
• Press the Clear key to return to the
normal program mode, OR
• Press key 0 to reset the counter for
this cycle to zero, OR
• Take the computer out of the
program mode.

Editing a Cycle

To edit a cycle in memory or to change, add,
or delete a step:
1. Insert key into the program mode switch
(located on the left side of the control
module) and turn key to the PROGRAM
position. The display will read "CYC00."
2. Press the Edit Cycle key on the keypad.
The display will read "DCYC00."
3. Press the two-digit code for the cycle
requiring editing: For example, press
key 2 and then key 5 to select cycle 25.
4. Press the Enter key. The computer will
search for cycle information for this cycle.
If no cycle information exists, the
computer will flash "NCYC25" followed
by "ADD?" To add this cycle, press the
Enter key and proceed to the add cycle
programming mode. If adding this cycle
is not desired, press the Clear key. The
computer will then return to the normal
programming mode.
38
(Continued)
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
5. If cycle information does exist for cycle
25, the computer will display "0425," for
example, to indicate that cycle 25 has been
run four times. To clear the count (reset it
to zero), press key 0. The display will
then show "0025."
If clearing the count is not necessary or if
it has just been cleared, press the Enter
key. The computer will now display
"HH0125," indicating the first step of
cycle 25.
6. Press the Advance key to move to the next
step of the cycle.
7. Press key 0 to back up to the previous step.
8. To access further information pertaining to
each step (for example, temperature and/or
time), press the Enter key.
If the display shows a temperature, press
the Enter key again to display the time.
9. Press the Enter key once more to advance
to the next step.
10. At any time, the programmer can put the
program mode switch in the RUN
position, and the computer will return to
normal running mode, provided all
pertinent data for the last step edited
is entered.
11. To change a step within the cycle, press
the Clear key once while the computer is
displaying the step to be edited. Enter the
new step, using the same procedure for
adding a step to a new cycle.
Note: If, after the Clear key is pressed, it is
decided that clearing the step is not desired,
press the Edit Cycle key to restore the step.
(This will work only if a step identification
was displayed before pressing the Clear key.
At other points in the step–such as a time or
temperature display–this restoration effort will
not work.)
F232089