Start Up; Opening Door; Loading - Alliance Laundry Systems UW35PV Instrucciones Se Operacion Y Programación De La Microcomputadora

Operation
Start-up
Turn on the main power source (circuit breaker
or cut-off switch on the wall).
When AC power is turned on, the front panel
display will show the program (ROM)
identification code.
This identification code will appear for
approximately five seconds. Then the
computer display will flash "POWER" and
"WAIT" alternately for two minutes.
The display will then show "NEXT00" to
indicate that a cycle can be selected. This
display will be shown at all times that power is
on between cycles, indicating that the door-
unlock solenoid will function if the door-
unlock button is pressed. The washer-extractor
is then ready for loading and unloading.

Opening Door

Use left hand to press and hold the door unlock
button located on the lower right front of the
control panel. See Figure 4.
Figure 4
18
MD003J
MD003J
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Use right hand to turn door handle clockwise
and swing the door left to open. See Figure 5.
Figure 5

Loading

CAUTION
Be careful around the open door,
particularly when loading from a level
below the door. Impact with door edges
can cause personal injury.
MD004J
MD004J
SW025
F232089