Step Programming; Programming A Fill Without Spray; Programming A Fill Temperature - Alliance Laundry Systems UW35PV Instrucciones Se Operacion Y Programación De La Microcomputadora

Programming

Step Programming

Programming a Fill without Spray

This process is used in temperature-controlled
fill steps. Water is added through the sump
only.
To program a fill without spray, program a
cold, hot, or warm fill to level as in a normal
fill step; however, instead of pressing the
Enter key after selecting the level, press the
Auxiliary key. The computer will display a
lower case "c," "h," or "w," instead of the
usual upper case "C," "H," or "W." Press the
Enter key now and program the time in the
usual manner.
Note: A fill without spray is programmable in
other fills.

Programming a Fill Temperature

The table on page 41 lists the required
procedures to produce specific results.
The table shows that when HIGH water level is
programmed, the display indicator is "H."
When MEDIUM level is programmed, the
display indicator is "M." When LOW level is
programmed, the display indicator is "L."
When OVERFLOW is programmed, the
display indicator is "O."
When the Warm key is pressed, the next key
pressed will be another temperature key (Hot,
Cold, or Warm) before selecting the level.
Exceptions to this will be when RINSE or
FLUSH steps are used: they require no level
commands, and water is added through the
door spray nozzle only.
40
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Each time the Warm key is pressed, one hot
and one cold water valve is turned on. The
machine is equipped with four water valves
(two fill and two spray); thus pressing the
Warm key twice will turn on all four valves
and reduce fill times.
Use the following procedure to program a
fill to a specific temperature:
1. The computer must be in PROGRAM
mode, and the cycle programming
sequence must be ready for the next step.
2. Press the Cold key. If this is the second
step of hypothetical cycle 25, the display
will read "C-0225." (HOT or WARM may
be programmed instead to control inlet
valves during the first three seconds of the
fill. After the first three seconds, the fill is
the same regardless of the prompt.)
3. Press the key representing the desired
water level (Low, Medium, High, or
Over). If High is pressed, for example,
the display will read "CH0225."
4. Press the Heat key. The display will read
either "080F25" or "025C25," depending
on whether Fahrenheit or Centigrade
is prompted.
Enter the desired fill temperature. Three
digits must be entered. If the desired
temperature is less than 100 degrees,
the first digit must be 0. If 100 degrees
Fahrenheit is selected, the display will
read "100F25."
The valid temperature range is 80–200
degrees Fahrenheit and 25–93 degrees
Centigrade. The computer will not accept
temperatures out of this range. (The fill
temperatures possible are governed by the
temperature of the available hot water.)
F232089