Replacing The Oven Light - Breville Joule Pro Manual De Instrucciones

STORAGE
1. Ensure the oven is turned off by removing
the power plug from the power outlet.
2. Allow the oven and all accessories to cool
completely before disassembling and
cleaning.
3. Ensure the oven and all accessories are
clean and dry.
4. Ensure the crumb tray is inserted into the
oven; the broiling rack is inserted into the
roasting pan and resting on the wire rack in
the middle rack height position.
5. Ensure the door is closed.
6. Store the appliance in an upright position
standing level on its support legs. Do not
store anything on top. The only exception is
the optional Breville Bamboo Cutting Board
and Serving Tray.
DO NOT STORE ITEMS ON
TOP OF THE OVEN
The top of the oven is very hot during and after
operation. As a result, storing items on top of
the oven is not recommended.
The only exception is the optional Breville
Bamboo Cutting Board and Serving Tray that
fits in the ribbed section on top of the oven.
Visit www.breville.com for more information.

REPLACING THE OVEN LIGHT

WARNING
Always unplug oven and let cool before
replacing bulb. Only use a 25 Watt, 120V, G9
type oven bulb.
1. Remove the wire rack from the oven before
replacing the light.
2. The light is positioned on the left-hand side
of the oven cavity. Position your fingers on
the outside of the light housing and gently
pull the glass cover away from the oven wall
to remove it. If you are unable to pull the
cover off, slide a spoon into the left side of
the light housing and gently lever the glass
cover off. Always hold the glass cover with
the other hand to prevent the cover from
falling and breaking.
30
3. Remove the used bulb by pulling it directly
out of its holder.
4. Use a soft cloth to insert the new bulb. Do
not directly touch the surface of the bulb
with your fingers as oil from your skin can
damage the bulb.
5. To reattach the glass cover, align the metal
hook with the left side of the light housing.
Slide the opposite end of the glass cover
into the metal bracket on the right side of
the housing, then push the metal hook into
the left side of the housing until it snaps
securely into position.