koban KPA 01 Manual De Instrucciones página 35

Note:
The Meter displays "OL" if the circuit is open or resistance is larger than
600Ω.
Capacitance
1. Insert the black lead into "COM" input and the red lead into "INPUT"
input.
2. Turn the rotary switch to "
for capacitance .
3. Place leads at the terminals of the capacitor after it is fully discharged.
4. Read the measurement from the display.
Inrush Current Measurement
1. Turn rotary switch to "A" position
2. Push "INRUSH"button to enter inrush current mode.
3. Open the clamp head by pressing the trigger and inserting the conductor
to be measured.
4. Power on the circuit being tested
5. Largest value will be held on main display
Note:
1. Measuring two or more wires together will cause false readings.
2. The wire being measured should be centered within the clamp.
3. The Meter displays "OL" if the circuit is overloaded.
Choose a larger range if possible.
4. Choose the largest range if the range of the circuit is unknown.
Temperature
1. Turn rotary switch to "TEMP" position.
2. Insert K-type thermocouple into the multi-function socket with the "+"
end in "INPUT" input and "-" into "COM" input.
3. Temperature reading will show on main display.
μA Current Measurement
1. Insert the black lead into "COM" input and the red lead into "INPUT"
input.
2. Turn the rotary switch to μA position.
3. Push "FUNC" to switch between AC/DC current
www.grupotemper.com
Digital clamp multimeter
" position and push "FUNC" three times
KPA 01
Instructions manual | 35