Operations Guide; Display Hold - koban KPA 01 Manual De Instrucciones

Operations Guide

Display Hold

During measuring, press the "HOLD" button once to hold the reading, press
again to release hold.
Manual Measurement
When using the rotary switch to switch between current, voltage, capacitance
and frequency mode, the default range type is Auto. Press "RANGE" button to
enter manual mode. Each press increases the measuring range and will return
to auto-range after maximum has been reached.
Note:
Manual Measurement Mode is disabled when performing frequency
measurement.
Backlight and Clamp light
1. Press the " /RANGE"button for 2 seconds to turn on the display backlight;
the backlight will stay on for 20 seconds before it is automatically turned
off.
2. When the backlight is on, press the " /RANGE"for 2 seconds to turn off
the backlight.
3. In current mode, turning on the backlight will also trigger the clamp light
Note: Backlight/clamp light uses and LED; even though the light will auto off
after 20 seconds, use only when needed to conserve power.
Maximum/Minimum recording
1. Press "MAX/MIN" button once to display the maximum measurement
and press "MAX/MIN" button again to display the minimum, press "MAX/
MIN" button a third time to return to normal mode.
2. In Max/Min mode, measurement is saved automatically.
3. Max/Min values are displayed on the secondary display while the current
measured value is displayed on the main display.
Note:
The Meter is set to manual mode when using Max/Min measurement.
www.grupotemper.com
KPA 01
Digital clamp multimeter
Instructions manual | 31