Diode Test - koban KPA 01 Manual De Instrucciones

KPA 01
Digital clamp multimeter
Note:
Frequency range is 10Hz ~ 60MHz. For frequencies below 10Hz, display will
show "00.0." For frequencies about 60kHz, duty cycle measurement accuracy
is not guaranteed.
Resistance
1. Insert the black test leads into "COM" input and red test lead into "INPUT"
input
2. Turn rotary switch to "
3. Connect the test leads across the circuit or resistors and read value on
LCD.
Note:
When the circuit is an open circuit, the Meter displays "OL" for overload.
For measurements above 1MΩ, the meter will take a few seconds to stabilize
the reading; this is normal for high resistance measurements.

Diode Test

1. Insert the black test leads into "COM" input and red test lead into "INPUT"
input
2. Turn rotary switch to "
test.
3. Connect the black lead to the cathode (-) and the red lead to the anode
(+) and read the value from the LCD.
Note:
The meter displays the forward biased value.
If the diode is connected backward or is an open circuit, the Meter will
display "OL".
Continuity
1. Insert the black test leads into "COM" input and red test lead into "INPUT"
input
2. Turn rotary switch to "
test.
3. Connect leads to the circuit terminals.
4. The meter will beep if the reading is below 50Ω.
5. Screen will show resistance value
Instructions manual | 34
" position for resistance measurement.
"position and push "FUNC" twice for
" position and push "FUNC" once for continuity
diode
www.grupotemper.com