Troubleshooting - Adler ECO35 Instalación Uso Y Mantenimiento

Ocultar thumbs Ver también para ECO35:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

THE DISHWASHER DOES NOT WORK ?
1- Verify inlet main water supply is correctly
connected, open and free
obstructions.
2- Verify main electrical supply is working
without
any
electrical
connections.
3- Verify the door is properly closed.
DISHWASHER DOES NOT WASH
WELL ?
1- Verify if the filters are cleaned, in case not,
clean them. (see par. 3D4)
2- Verify if the washing water jets on the
washing arms are not obstructed by any solid
residues.
3- Verify if used a correct amount and quality of
detergent and rinse aid. (see par. 3B2/3C2)
4- Verify if the dishes are correctly loaded on
the dishwasher. (see par. 3B6/3C7)
5- Washing cycle used is too short. Use another
cycle (if available) or repeat the washing
cycle.
THE DISHES ARE NOT RINSED WELL?
1- Verify if the rinse water jets on the washing
arms are not obstructed by any solid
residues.
2- Verify solenoid valve filter is free from any
obstructions such as lime or scale.
3- The inlet water pressure is inferior of 2 bar –
200 kPA. Install an external pressure device
to ensure and increase the inlet water
pressure inside the machine.
THE DISHES ARE NOT DRIED WELL ?
1- Ask the assistance service to verify the
instruction for the rinse aid dosing. (see par.
2D)
2- Verify if the rinse aid container is empty. If
yes, fill it with rinse aid product. (see par. 2D)
3- Verify the quality and the quantity of the
rinse aid used and check with the assistance
service. (see par. 2D)
4- Verify the rinsing temperature is between
80°C (176°F) to 90°C (194°F) degrees.
4

– TROUBLESHOOTING

CONDENSATION ON GLASSES ?
1- Verify if the rinse aid container is empty.
from
any
2- Verify the quality and the quantity of the
breakdown
3- Download the glasses rack immediately
STAINS ON GLASSES ?
1- Use only non foaming products for
EXCESSIVE FOAM IN THE TANK ?
1- Verify washing water temperature is not
2- Ask the assistance service to verify the
3- Ensure the tank has not been cleaned
4- If foaming detergent has been used,
SMEARS
GLASSES ?
1- Ask the assistance service to verify the
IN
EXTINGUISHER MUST BE USED.
IN
IMMEDIATLY THE AUTOMATIC GENERAL
ELECTRICAL SWITCH.
The Manufacturer reserves the right to
modify the appliances presented in this
publication without notice.
Produced and Built in Italy – P.IVA 00740990163
If yes, fill it with rinse aid product. (see
par. 2D)
rinse aid used and check with the
assistance service. (see par. 2D)
after the end of each cycle.
professional dishwashers.
less than 50°C (122°F) degrees.
instruction for the rinse aid dosing. (see
par. 2D)
with unsuitable cleaners. Drain the tank
and rinse throughly before new wash
cycles.
drain and refill the tank with water until
the foam disappears.
OR
SPOTS
instruction for the rinse aid dosing.
EMERGENCY
CASE
OF
FIRE
CASE
OF
DANGER
ON
THE
A
POWDER
CUT-OFF
20
Tabla de contenido
loading

Productos relacionados para Adler ECO35

Tabla de contenido