Warning Messages Displayed On The Control Panel - Adler ECO35 Instalación Uso Y Mantenimiento

3F – WARNING MESSAGES
DISPLAYED ON THE CONTROL PANEL
(Elettronic versions only)
N.B.
If the machine is in OFF mode, warning
messages are not visualized on the display.
Turn ON the machine to visualize type of error
or breakdown.
The following warning messages are visualized
on the display:
ntcb
E-01 BOOSTER TEMPERATURE PROBE
Booster temperature probe not connected or
faulty.
CALL TECHNICAL SERVICE ASSISTANCE
ntcu
E-02 TANK TEMPERATURE PROBE
Tank temperature probe not connected or faulty.
CALL TECHNICAL SERVICE ASSISTANCE
fill
E-03 WATER FILL
Water fill not completed during the available
maximum time (10min).
Verify that water supply is correctly connected,
opened and free of obstructions.
Verify that solenoid valve filter is free of possible
obstructions and deposit.
Verify that water supply pressure is adequate
(par.1D – Technical Data).
Verify that machine's door is completely closed
and the overflow device is correctly positioned
inside the tank.
N.B.
If water fill timing expires or in case of water
level signal is not respected solenoid valve is
automatically interrupted. To restart solenoid
valve press any button on the control panel.
Tbo
E-04 BOOSTER TEMPERATURE LIMIT
Booster temperature maximum
reached (set point +14°C / 57°F).
CALL TECHNICAL SERVICE ASSISTANCE
TUA
E-05
Tank temperature maximum set point
reached (set point +7°C / 44°F).
CALL TECHNICAL SERVICE ASSISTANCE
drA
E-06
Drainage not completed on the maximum
programmed timing
Verify that the overflow device is completely
removed and not obstructions are present on
the water drain line.
bnot
E-07
Maximum booster heating time reached
(15min).
CALL TECHNICAL SERVICE ASSISTANCE
Unot
E-08
Maximum tank heating time reached
(30min).
CALL TECHNICAL SERVICE ASSISTANCE
SEruICE
E-09
DAMAGED BOARD
Memory parameters error or damaged board.
CALL TECHNICAL SERVICE ASSISTANCE
FOLLOWING ACTIONS AFTER MACHINE
Booster and tank heating elements are
interrupted, water load is disactivated,
control panel display visualizes the error and
the electronic card is inactivated. All led
buttons are OFF. Washing cycle is interupted
(stanby mode) and restored if the problem is
solved. It is always possible to turn OFF the
machine by pressing button "A" ON/OFF, and
if the problem is solved, warning messages
are not more displayed.
set point
TANK TEMPERATURE LIMIT
DRAIN ANOMALY
.
BOOSTER HEATING
TANK HEATING
PARAMETERS ERROR
ERROR OR BREAKDOWN:
OR
19