Undercounter Dishwasher With Built- In Water Softener - Adler ECO35 Instalación Uso Y Mantenimiento

Ocultar thumbs Ver también para ECO35:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

4- Wait until all the water is completely drained
out from the tank. The machine will turn OFF
automatically after completing drain process.
3D3 – WATER DRAIN (
MECHANICAL MACHINE
WITH DRAIN PUMP INCLUDED
1- Open the door and remove the water flow
device and close the door. (Fig.41)
Fig.41
2- Press button "B" to start drain out the water
and wait until all the water is completely
drained out from the tank. (Fig.42)
B
Fig.42
3- Turn OFF the machine by pressing button "A"
On/Off.
3D4 – FILTERS CLEANNING
1- Turn OFF the machine by pressing button "A"
On/Off.
2- Manually remove side or central filters or by
unscrewing the ferrule located on the top
rounded filter inside the tank. (Fig.43)
Fig.43
3- Wash and clean filters accurately on running
fresh water.
4- Repositionated all filters and components
inside the machine.
3D5 – EXTERNAL SURFACES CLEANNING
Before carrying out any cleanning operations,
turn off the power at the mains.
To reduce the emmission of pollutants into the
enviroment, clean the appliance (externally
and
where
necessary
products having a biodegradability of over
90%.
WARNING!
CLEAN STAINLESS STEEL SURFACES BY USING
WARM
SOAPY
WATER;
DETERGENT CONTAINING ABRASIVE
SUBSTANCES
NOR
COMMON WIRE WOOL, BRUSHES OR
)
internally)
with
NEVER
USE
STEEL
SCRAPERS,
SCRAPES; RINSE THOROUGHLY USING A
WET CLOTH AND CAREFULLY WIPE DRY.
DO NOT WASH THE APPLIANCE BY USING
DIRECT OR HIGH PRESSURE WATER JETS.
3D6 – TURNING OFF THE MACHINE
1- Drain out completely the water from the
tank. (see par.3D1/2/3)
2- Turn OFF the machine by pressing
button "A" On/Off.
3- Close the door and turn off the power at
the mains.
3E – UNDERCOUNTER
DISHWASHER WITH BUILT- IN
WATER SOFTENER
These models have continuous softener in
the dishwasher water circuit. By means of
special resins, this device removes the
calcareous substance from the feed water,
supplying decalcified water for washing.
Automatic watersoftener works properly if
the resins are regenerated periodically, with
frequency depending on the hardness of the
water and the number of wash cycles carries
out.
3E1 – SALT CONTAINER / FILLING
The water can be only softened if there is salt
in its container. The salt container must be
filled when the dishwasher is used for the
first time and before starting a new cycle.
3E2 – MECHANICAL VERSIONS
It is necessary to fill the salt container
approximately
every
regenerations.
3E3 – ELECTRONIC VERSIONS
If available, fill salt container everytime the
message "Add SALt" is displayed or during
blinking button on the control panel.
Add
SALt
N.B. (Mechanical / Electronic Versions)
It is not possible to start a new
watersoftener
regeneration
container
is
empty.
regeneration process must be made only
after draining out completely the water
inside the tank. Salt container has always
water on its inside; however it is normal if
some water comes out of salt container
while filling it.
5
watersoftener
ADD SALT
if
salt
Watersoftener
17
Tabla de contenido
loading

Tabla de contenido