Cleaning And Care - Parkside PABK 60 B3 Instrucciones De Utilización Y De Seguridad

Cleaning and care

Cleaning and care
Thoroughly clean the spray stylus
ately after use. Otherwise the paint can dry
and cause problems during the next use.
Rinse out the spray stylus
water. Do the same with the mini paint spray
gun.
Note: should the compressor's air duct be
dirty, remove the sucked in dirt using a dry
cloth.
ATTENTION!
Never submerge the paint spray gun in solvents.
After each use, spray thinner (only in the open
air – danger of explosion!) or water through
the device.
Use a cleaning brush or a cloth. to clean the
casing, the nozzle head and the spray holes
contained within. Never use petrol, solvents or
cleaning agents that attack plastic.
First screw out the material amount regulation
screw by turning in an anticlockwise direction.
Remove the spring.
Remove the needle using pliers (see Figure A).
Clean the needle carefully using the brush
(tooth / nail brush) (see Figure B).
Put the needle back in the paint spray gun.
Place the spring on the end of the needle.
Error
Cause
1. Paint almost
empty
2. Viscosity too
high
3. Nozzle loose /
defective
Screw the material amount regulation screw
tight by turning in a clockwise direction.
Unscrew the gravity flow cup from the mini spray
gun by turning in an anticlockwise direction.
32 GB/IE
285126_Airbrush-Set PABK 60 B3_content_OS.indd 32
immedi-
3
thoroughly with
3
Interrupted paint jet
or intermittent
colour coverage
Solution
1. Fill paint
2. Lower viscosity
3. Replace / screw nozzle
tight
Remove the filter as shown in Figure C and
clean this with a tooth / nail brush.
Also clean the gravity flow cup's inner screw
thread using a tooth or nail brush (see Figure D).
Insert the filter back into the gun (see Figure C)
and screw the gravity flow cup tight in a clock-
wise direction.
For rust protection you can spray sewing
machine oil through the device after cleaning.
For this purpose, spray sewing machine oil in
through the spray gun.
Oil all moving parts regularly to ensure the
smooth operation of the device.
After cleaning the needle, the thread and seal
must be lightly greased.
Do not use any lubricants containing silicone.
Only store pneumatic tools in dry areas.
Error Reduced performance
Cause Solution
4. Paint supply 4. Clean
restricted
5. Correct angle of
5. Spray stylus
3
position
in incorrect
position
Error Spray pattern not
complete
Cause Solution
1. Air head dirty / 1. Clean / replace air
defective head
1. Rinse with clear water
2. Contaminated / 2. Clean / replace nozzle
defective nozzle
Error Spray pattern
irregular with
formation of drops
Cause Solution
1. Defective nozzle 1. Replace nozzle.
Go to a suitable service
station for this purpose.
2. Viscosity too high 2. Lower viscosity
19.06.17 16:14