Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Connect airbrush set
Always unplug from the mains before you
connect the airbrush set with the compressor.
Use the relevant screw connection to connect
the spray stylus
3
and the coiled hose to the airbrush compressor
. Use the included open-end wrench.
1
(see Fig. A).
Fasten the paint mixing beaker with the con-
nection lid to the spray stylus
Connect the mains plug to the mains socket.
Note: for optimal results, professionals use an
interposed pressure reducer (not included in
delivery). The pressure reducer can be used to
adjust the compressed air at the spray gun and
optimise it to your needs.
Mixing paints for use
The paints included are water-soluble. In order to
properly apply the paints, add water and stir. As
delivered, the paints are too viscous.
Shake the colour tube with the cap still on.
Put 3-4 drops of the colour in the mixing
beaker.
Fill the jar half full with water and stir with the
stirring rod
.
24
It is important that there are no clumps. Screw
the lid onto the beaker.
Connect the paint mixing beaker
Figure B.
Note: if you wish, you can use the quantity of
water you add to influence the colour strength,
as with water colour paints. The more water
you add, the "thinner" the colour. You can also
mix individualised colour tones from the availa-
ble colour pastes. Ensure that there are no
paint clumps in the paint containers. The con-
sistency should correspond to that of water.
Note: if the used colour is too opaque, in-
crease the quantity of colour in the mixture.
285126_Airbrush-Set PABK 60 B3_content_OS.indd 29
with the coiled hose
2
10
(see Fig. B).
3
according
4
Switching the airbrush
compressor on / off
Turn the airbrush compressor
the on / off switch
to the position "I" (see
5
Fig. C).
Turn the airbrush compressor
the on / off switch
to the
5
position "0" (see Fig. C).
Note: full pressure is reached after approx.
two seconds.
Regulating the air pressure
Regulate the air pressure by adjusting the air
pressure measurement button on the top side
of the spray stylus
.
3
The air pressure can be adjusted by turning the
air pressure regulator
.
6
The level of air pressure will be shown on the
pneumatic display.
Turning the air pressure regulator
lowers air pressure; turning the air pressure reg-
ulator
to the right increases air pressure.
6
An internal valve bleeds overpressure if it is not
reduced.
Regulating the result of the
spray stylus
Regulate quantity of paint in use and therefore
also the result of the spraying by turning paint
nozzle on the spray stylus to the left (see Fig. B).
Connecting the pneumatic hose
Connect the pneumatic hose
compressor
. Use the included open-end
1
spanner
to do so (compare Fig. A).
10
Initial use
on by setting
1
off by setting
1
to the left
6
to the airbrush
7
GB/IE
29
19.06.17 16:14
Capítulos
Tabla de contenido
