Health And Safety; Observations - Sagola ATLANTA 800 G Manual De Instrucciones

In order to carry out maintenance, repairs or cleaning, first
disconnect the unit from the compressed air network, after
having correctly carried out the DEPRESSURISATION
procedure described in Section 13 of the Manual.
Never point the unit towards yourself, other personnel or
animals. The thinners and dilution media used can cause
serious injury. With this unit the product is sprayed at a
very high pressure. The stream coming from the gun, from
leaks, or due to the breakage of a component in the unit,
could cause the product to be injected at high pressure
under the skin. LIkewise if the product is sprayed or splas-
hed in the eyes it
can cause serious harm.
Never attempt to stop the application stream or a leak with
your hand or any other part of your body. If you suspect
you may have sprayed the product on your skin, IMMEDIA-
TELY SEEK MEDICAL ATTENTION. This incidence must
not be treated as a simple cut. Describe the product with
which it ocurred to the Doctor in as much detail as possible.
The location where work is carried out must have sufficient
ventilation in accordance with current legislation and
regulations.
Near the unit, only keep the amount of product and thinner
required for the work being done at that time. After work
has been completed, thinners and the product to be
applied must be returned to their corresponding storage
location.
Keep the working area clean and free of potentially dange-
rous waste (thinners, rags, etc.) While work is in progress,
there must not be any source of ignition (naked flames,
lighted cigarettes, etc.) in the working area as these might
generate easily flammable gases. Likewise, the approved
protective means must be used (breathing, hearing, etc.) in
accordance with the regulations established in this regard.
If the unit is used in an inadequate manner or its compo-
nents are altered in any way, severe material damage may
occur and bodily harm may be caused to the operator,
other personnel and/or animals and may even cause
death. SAGOLA, S.A. accepts no responsibility in for any
damage caused through the incorrect use of the unit.
Always use approved breathing units in accordance with
current standards and regulations in order to protect
yourself from emissions produced during application.
Never exceed the maximum operation pressure.
By following the instructions set out in this manual you will
ensure good spraying and quality of finish. Should you

17. HEALTH AND SAFETY

As a general preventive measure we advise you to wear
goggles in accordance with the specific environmental
regulations and characteristics for the work centre.
Use gloves when handling the product (see the manufactu-
rer's recommendations) and cleaning the gun.
If, when the gun is in use, the ambient noise level excedes
90 dB. the use of approved hearing protection is recom-
mended. The gun in itself does not propitiate any mechani-
cal risk of perforations, impact or pinching, except those
deriving from incorrect installations and handling.
USE SAGOLA ANTISTATIC HOSES TO ELIMINATE
POSSIBLE ELECTRICAL DISCHARGES THAT MIGHT
CREATE THE RISK OF FIRE OR EXPLOSION.
Pay adequate attention when handling the unit in order to
prevent any damage that might lead to dangerous
situations for the user or personnel standing near the unit,
as a consequence of leaks, breakages, etc.
The equipment has been designed for use at ambient
temperature. The maximum operating temperature is
50ºC.
The use of solvents and/or detergents that contain haloge-
nated hydrocarbons (trichloroethane, methyl chloride,
etc.), may cause chemical reactions in the unit as well as in
its zinc-coated components (trichloroethane mixed with
small amounts of water produces hydrochloric acid). For
this reason, these components may rust and in extreme
cases the chemical reaction caused may be explosive. We
recommend you use products that do not contain the afore-
mentioned components.
Do not use acids, soda (alkalis or pickling substances, etc.)
for cleaning under any circumstances.
In general, precautions must be taken whenever the unit is
handled, in order to prevent any deterioration to it.
Connectors must be securely tightened and in good condi-
tion.
Safety standards must be understood and applied.
Any non-compliance with the indications set out in this
manual may lead to incidents affecting the physical integri-
ty of the user or other personnel or animals.
Respect and comply with indications relating to the conser-
vation of the environment

18. OBSERVATIONS

have any doubt, please contact the Technical Service of
SAGOLA S.A.
- 27 -