Lubrication; Health And Safety - Sagola 3300GTO Manual De Instrucciones

26/27
For automatic cleaning of the gun, tools and accessories used in the mixing and preparation of the
product to be applied, we recommend the use of SAGOLA washing machines.
IMPORTANT
The gun can be cleaned with thinners or detergents in a gun washing machine. If you opt for this
cleaning system, we advise you to remember the following considerations, which, if not applied,
may damage the gun and render the warranty null and void:
- Do not submerge the gun in solvent or detergents longer than the time required for cleaning.
- Do not use the gun immediately after cleaning has been completed.
- Ensure that there is no thinner or detergent inside and that it is completely free of these
substances. Other cleaning systems can be used (ultrasound).

14. Lubrication

The original lubrication of the gun is eliminated through use and cleaning. In
order to guarantee perfect operation, it is necessary to grease the regula-
ting or fastening threads, friction areas, etc., on a periodic basis, especially
after each cleaning session and with greater care if the gun has been
cleaned in a machine. Moving parts must be lubricated lightly after
cleaning has been completed.
We recommend you to use a light SAE 10 oil or natural grease or vasoline.
It is important to check that the lubricant used does not contain components that might impair the
spraying quality (Silicones, etc.)

15. Health and Safety

In order to carry out maintenance, repairs or cleaning, first disconnect the unit from the compres-
sed air distribution network.
Safe disconnection from the compressed air network:
If there is any cleaning liquid or product remaining in the tank, return it to its corresponding
container. If the pneumatic connector is fitted in the air inlet, disconnect the hose from the pistol.
If it is not, depressurise the air hose properly and, using a spanner, unscrew the end of the hose
from the air inlet connector, holding the pistol firmly.
Safe connection to the compressed air network:
If the pneumatic connector is fitted in the air inlet, connect the hose to the pistol. If it is not, hold
the pistol firmly and, using a spanner, screw the end of the hose into the air inlet connector. Check
there are no leaks.
Safe disconnection of the product cup:
Carry out the cleaning according to point 14. Disconnect the tank by unscrewing the product inlet
connector, holding the body of the pistol firmly.
Safe connection of the product cup:
Connect the tank by screwing on the product inlet connector, holding the body of the pistol firmly.
Check there are no leaks.
Never point the unit towards yourself, others or animals. The thinners and dilution media used
can cause serious injury.
We recommend using this unit in premises with forced ventilation and in accordance with the
current standards and provisions on the matter.
Near the unit, only keep the amount of product and thinner required for the work being done at
that time. After work has been completed, thinners and the product to be applied must be returned
to their corresponding storage location.
Keep the working area clean and free of potentially dangerous waste (thinners, rags, etc...).
While work is in progress, there must not be any source of ignition (naked flames, lighted cigaret-
tes, etc.) in the working area as these might generate easily flammable gases. Likewise, the
approved protective means must be used (breathing, hearing, etc.) in accordance with the
regulations established in this regard.
ENGLISH