Useful Tips; Functional Description Of The Equipment; Repair And Maintenance Kit - Sagola ATLANTA 800 G Manual De Instrucciones

- Use the lowest spray pressure in the air cap, allowing you
to obtain the required finish.
Not all products require the maximum pressure for correct
spraying. With lower pressure there is an additional increa-
se in product transfer.
- Pay special attention to the application speed. The
thickness of the film deposited may be greater than planned
if the application speed is low, and the opposite is also true.
- If the thickness of the layer is very thin, this is due to the
fact that the air pressure is excessive for the amount of
product being applied. Reduce the air pressure in the gun
in order to ensure that the thinner in the paint does not
evaporate during spraying and that it is not dry when it
reaches the surface to be painted. Increase the amount of

7. FUNCTIONAL DESCRIPTION OF THE EQUIPMENT

The equipments ATLANTA 800G y 800G Signaling can
be used to apply medium viscosity products used widely in
the Construction, Timber, Plastics Industry, etc.
The product to be applied (plastic paints, primers, varni-
shes, waterproof, fireproof, bituminous, epoxies, chlorina-
ted rubber for use in Signage, and all kinds of products of
low and medium viscosity) is kept in the container supplied
by the manufacturer.
SAGOLA S.A. has service Kits for the repair and replacement of consumable components in the unit, indicated in the explo-
ded view sheets.
KIT No. REFERENCE
17 300 900 87
14 864 652 04
42 300 900 21
43 875 600 03
45 300 900 70
47 300 900 22
50 864 647 03
48 857 700 99
61 857 600 94
32 864 640 03
54 864 100 68
25 864 100 73
300 900 99
Road marking kit
KIT No. REFERENCE
300 900 60
864 600 28
91 300 100 13

6. USEFUL TIPS

8. REPAIR AND MAINTENANCE KIT

product, correct its viscosity or use a larger air cap in the
gun.
- If the film is very thick or granulated, this is due to the fact
that the amount of product to be applied is excessive for
the pressure used. Decrease the amount of product,
reduce its viscosity or use a smaller air cap in the gun.
- If sagging occurs, this is due to the fact that the amount of
product to be applied is excessive for the pressure used,
the viscosity is not correct or the application speed is not
adequate.
Decrease the amount of product, adjust its viscosity or
increase the application speed until the required finish is
obtained.
From the manufacturer's container, with the unit in opera-
tion, by means of suction and through the probe it flows to
the interior of the unit.
From the unit, through the product hose and the gun, the
product is sprayed.
KIT NAME
Drain assembly
Complete suction probe
Non return valve
Suction valve
Upper block
Diaphragm
Regulator
Oil suction elbow
Petrol motor coupling
Petrol engine
Oil level
Antipulsation filter
Oil Renolin MR-10 (1 liter)
KIT NAME
ROAD MARKING KIT
Road marking gun
Needle kit
(includes needle + proportioning
head+seal)
- 20 -
(includes road marking gun)