LaMotte WaterLink SpinTouch Manual Del Usario página 12

WARNING: only use the USB cable and wall adapter that are supplied with the kit. Make no
substitutions.
BATTERY
A fully charged battery will last for approximately 150 tests under average conditions. The
battery life will vary based on usage patterns. The meter should be turned off after testing
to prolong the battery life. The standard life cycle of a lithium ion battery is 500 cycles.
The battery will fully charge in approximately 10-12 hours. The battery is designed to be
charged overnight and should be charged indoors only. The battery is rated at 12 V and 8.1
AH capacity. Power the meter from the battery pack or from AC power. The USB cable and
AC adapter are used to plug the meter into an AC outlet. WARNING: only use the AC adapter
supplied with this equipment. Do not substitute.
The battery charge status is indicated by the battery icon on the display. The battery icon
will indicate when the battery charge is full, partial, low, empty or charging. The empty
battery icon will fl ash to indicate that meter should be connected to AC power source. If the
meter continues to be used at low battery power without connecting it an AC power source,
the meter will go into an auto-shutdown mode. In this mode the meter will be locked until
meter is connected to an AC source and the battery is charged to a suffi cient voltage.
While charging, the charging battery icon will be displayed. The meter
should remain plugged in until the battery is fully charged. When the
battery is completely charged, the charging icon will change to the full
battery icon.
SETTINGS
Tap to enter the SETTINGS menu. Tap
Brightness
Date/Time
Set Language
Calibration
Power
Options
Bluetooth
Market Type
The brightness level of the display can be adjusted from 00 to 10. Tap
to adjust the brightness. Tap
The Year, Month, Day, Format, Hour, Minute, AM/PM can be set. Tap
to adjust the displayed value. Tap
last value has been chosen (minutes for 24 hour format, AM/PM for 12 hour
format) tap to return to the Settings menu. Tap
menu at any time.
There are ten language options – English, French, Italian, Portuguese,
Spanish, Chinese, German, Dutch, Swedish, Turkish. Tap selection. Tap
exit to the Settings menu.
Tap to run an angle calibration to evaluate the alignment of the hub and disk.
Tap to exit to the Settings menu.
There are three power options: Auto Dim Time, Auto Off Time, and Power. Tap
the options then tap a selection. Tap selection. Tap
menu.
There are two Bluetooth options: Bluetooth Enabled and Fast Printer Connect
that are used to transfer and print test results. Tap
menu.
Tap to select the market type. Select Pool/Spa. Tap
menu.
to return to the test screen at any time.
to exit to the Settings menu.
to move to the next value. After the
12
and
or
to exit to the Settings
to
to exit to the Settings
to exit to the Settings
to exit to the Settings