Replacing The Battery Of The Remote Control - Philips FC8820 Manual Del Usaurio

Problem Cause
The robot does The rechargeable battery is
not start cleaning empty.
when I press the
on/off button.
The small plug is still inserted
in the socket on the robot.
E1 is on the One or both wheels are stuck. Set the on/off switch to 'off '. Remove the fluff,
display.
One or both side brushes are
stuck.
E2 is on the The top cover is not present
display. or is not closed properly.

Replacing the battery of the remote control

The remote control works on a CR2025 coin-shaped battery. Replace the
battery when the robot no longer responds when you press the buttons
on the remote control.
1 Hold the remote control upside down. Push the release button on
the battery holder and at the same time slide the battery holder out
of the remote control.
2 Remove the empty battery from the battery holder and place a new
battery in the battery holder. Then slide the battery holder back into
the remote control.
Ordering new dry wipes
You can order new dry wipes under order number CP0123.
Troubleshooting
This chapter summarises the most common problems you could
encounter with this appliance. If you are unable to solve the problem with
the information below, visit www.philips.com/support for a list of
frequently asked questions or contact the Consumer Care Centre in your
country.
Solution
Charge the rechargeable battery
(see chapter 'Preparing for use').
The robot does not work on mains power. It only
works on its rechargeable battery.
Therefore, always disconnect the adapter from
the robot and the mains before use.
hair, thread or wire that is caught around the
wheel suspension.
Clean the side brushes (see chapter 'Cleaning and
maintenance').
When the top cover is not present or is not
closed properly, the robot does not work.
Place the top cover on the robot properly.
ENGLISH
23