Cleaning And Maintenance; Emptying And Cleaning The Dust Container - Philips FC8820 Manual Del Usaurio

2 Take four new AA batteries from the pack and insert them into the
battery compartment of the virtual wall unit.
Note: Make sure the + and - poles of the batteries point in the right direction.
3 Slide the back cover onto the virtual wall unit again.
Positioning the virtual wall unit to stop the robot
You can use the virtual wall unit to prevent the robot from entering a
room or area that you want to keep it out of.
1 Place the unit at a spot beyond which you do not want the robot to
go, e.g near an open door to a room that is off-limits to the robot or
at the top of a staircase.
2 Switch on the virtual wall unit with the on/off slide on top of the unit.
3 Switch on the robot for a normal cleaning run.
4 When the robot comes too close to the virtual wall unit, the light
on the virtual wall unit starts flashing and the virtual wall unit emits
a beam of infrared light. This beam of infrared light makes the robot
change its course and move away from the virtual wall unit.

Cleaning and maintenance

Emptying and cleaning the dust container

Empty and clean the dust container when the dust container full icon on
the display of the robot lights up.
1 Remove the top cover.
Note: Make sure the power switch is in 'off ' position.
ENGLISH
19