Information On Data Protection - Bosch MTS 6531 Guia De Inicio Rapido

Connect diagnostic device to the vehicle | MTS 6531 | 3
4. Connect diagnostic
device to the vehicle
Fig. 3: View right side with OBD and 2x USB Type A
!
Only use MTS 6531 in combination with origi-
nal and approved hardware and software.
Use of MTS 6531 and recording of
diagnostic data while driving may
only be carried out by trained and
instructed employees of the service
workshop.
WARNING - Risk of accident when
used while driving
Impairment of driving safety and
braking effect by connecting cables in
the driver's area and distraction when
using while driving. Death or serious
injury.
¶
Place, lay and secure MTS 6531
and all connecting cables in such a
way that there is no impairment of
driving safety and braking effect.
¶
Use of MTS 6531 and recording of
diagnostic data while driving may
only be carried out by trained and
instructed employees of the service
workshop.
¶
MTS 6531 must be operated by a
second person (not driver) while
driving.
¶
During the data recording always
observe the legal requirements for
road traffic.
1. Connect the MTS 6531 (fig. 1 item 1) to the
OBD connection of the vehicle using the OBD
connecting cable (fig. 1 item 2).
2. Start the diagnosis software.
3. Follow the software instructions.
Robert Bosch GmbH
5. Using wireless commu-
nication
If you are using the kit with WLAN then you can
communicate with the vehicle without using the
USB connecting cable. To configure the WLAN
connection MTS 6531 – computer, please see
chapter "WLAN" in the operating instructions of
MTS 6531.
6. Information on Data
Protection
!
The data processing performed by this device
may be protected by regional data protection
regulations. Processed categories of data are
vehicle master data (data generated in the
vehicle during manufacturing like the vehicle
identification number VIN), and vehicle event
data (data generated by the vehicle after
manufacturing). The processing purpose is
control unit diagnosis.
2019-07-01
en
|
1 689 989 442