Elvox 68TC/K Manual Para El Conexionado Y El Uso página 8

Cámara ccd con aparato externo para videokit 2 fili y placa 13k1
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 18
GB
Fig.16A
Red/black cable
Green/green cable
Fig.17
3
2
1
Installation of entrance panel (type 13K1), surface wall-mounting version
-
Open the entrance panel by undoing the screw under the plate (G) and
detach the camera (B) from the frame, removing the light diffuser (H)
and the microphone (I).
-
Install the frame (C) together with the surface wall-mounting back box
(P) on the wall with the bottom edge at a height of approx. 1.65m from
the ground.
-
Reposition the camera in the frame and the microphone in the special
housing (B), refitting the plug as shown in fig. 16A.
-
Connect the camera to the name card lighting LED board using the two
cable harnesses (harness with red/black wire for LED power supply and
harness with two green wires for connection of a second call button, if
required) fig.16B.
Art. 68TC/K, 68TU/K
Fig.16B
12V
LED CH2
Art. R130)
(
E
Art. R135)
(
F
-
Make the connections to the installation on the removable terminal
block (L).
In the case of installation for two-family video door entry systems:
-
Remove the blanking module (E) fig. 17, from the back of the plate using
a screwdriver, working in sequence from bottom to top (first remove the
end section, then key 1 and finally the blanking module.
-
Fit the external key (F) (supplied) to the plate by pushing it lightly into
place.
-
Insert the light diffuser (H) to ensure even lighting of the name cards.
-
Close the entrance panel, securing it to the frame with the aid of a
screwdriver.
Fig.18
A
B
C
P
8/32
G
H
L
I
M
N
O
Tabla de contenido
loading

Este manual también es adecuado para:

68tu/k

Tabla de contenido