Elvox 68TC/K Manual Para El Conexionado Y El Uso página 7

Lens orientation
Camera unit Type. 68TU/K (68TC/K) can be adjusted manually on the verti-
cal and horizontal axis to improve the shooting angle, the screw on the
upper side of the lens loosen, turn the lens in the required direction and fix
the screw.
Fig.14A
ENTRANCE PANEL FOR VIDEO DOOR ENTRY SYSTEMS
Before installing equipment, choose location for camera entrance panel: the
camera shouid be protected from direct light (sun, car headlights, etc.) as
this may affect the quality of the picture, and may damage the camera. It is
advisable to protect panel with some form of weatherproof shelter.
The video camera is equipped with LEDs for night illumination of the sub-
ject up to a distance of 1 metre approx.
Art. 68TC/K, 68TU/K
Installation of entrance panel (type 13K1), flush-mounting version
- Install the flush-mounting back box (D) on the wall with the bottom edge
- Open the entrance panel by undoing the screw under the plate (G) and de-
Fixing screw - Fit the frame (C) to the flush-mounting back box (D)
- Reposition the camera in the frame and the microphone in the special hou-
- Connect the camera to the name card lighting LED board using the two
- Make the connections to the installation on the removable terminal block
- Remove the blanking module (E) fig. 17, from the back of the plate using
- Fit the external key (F) (supplied) to the plate by pushing it lightly into place.
- Insert the light diffuser (H) to ensure even lighting of the name cards.
- Close the entrance panel, securing it to the frame with the aid of a screw-
Fig.15
Fig.14B
7/32
at a height of approx. 1.65m from the ground
tach the camera (B) from the frame, removing the light diffuser (H) and the
microphone (I).
sing, refitting the plug as shown in fig.16A.
cable harnesses (harness with red/black wire for LED power supply and
harness with two green wires for connection of a second call button, if re-
quired) fig.16B.
(L).
In the case of installation for two-family video door entry systems:
a screwdriver, working in sequence from bottom to top (first remove the
end section, then key 1 and finally the blanking module).
driver.
A
B
C
D
GB
G
H
L
I
M
N
O