Wiring; Installation Procedure - koban KDP7 Serie Manual De Instrucciones

Pay attention to the walking direction in the test proceeding (See FIG.4).

Wiring

L
N
Control
Switch
L
Motion sensor

Installation procedure

The detector can be mounted either on the wall or on the ceiling.
1. Detach the sensor part from the bottom case, then fix the bottom case on
the wall or on the ceiling with the screws (See FIG.7 & FIG.8).
2. Feed the cables through rubber gasket and refer to wiring diagram
to connect the cables, please be noted to strip off 6 - 8mm of cable
sheathing by tool (See FIG.5 & FIG.6 & FIG.7).
3. Arrange cables with a cable clamp and secure it with two screws. The
terminal block has to be pressed in between two bosses of bottom case
(See FIG.9).
4. Connect the sensor base with the power box cover, then fix firmly with 2
screws (See FIG.10).
www.grupotemper.com
Less
sensitive
FIG.4
N
FIG.5
Motion detector light control
More
sensitive
(from sensor)
Brown Blue Red
L N
FIG.6
Instructions manual |
KDP7
From lamp
17