Tabla de contenido
Idiomas disponibles
Idiomas disponibles
1 0
USAGE AND WARNING
WARNING !!!
If away for a long periods (eg holidays) we
recommend that you turn off the water
supply to the WC served by the unit.
WCs connected to this unit can be used like
any normal toilet, and requires minimum
maintenance. The unit will operate
automatically as soon as the required level
of water enters the case.
This is a domestic unit.
For horizontal pipework:
• Minimum fall of 1:200 to the soil stack,
• Avoid any dips in the discharge pipe.
WARNING !!!
Only the disposal of toilet papers, faecal
matter, and waste water will be under
guarantee. Any damage due to foreign
bodies such as cotton, condoms, sanitary
towels, wet wipes, food, hair, metal, wood
or plastic objects, will not be under
guarantee. Solvents, acids and other
chemicals can also cause damage to the
unit, and will invalidate the guarantee.
1 1
CARE OF YOUR UNIT
In order to remove scale and clean the
macerator and the bowl, use a household
descalent.
• Disconnect the macerator power,
• Pour an amount of descalent in the pan
• leave it to stand for 1 or 2 hours,
• Re-connect the macerator power,
• Rinse by operating the flushing system twice.
Carry out the operation once every 3 months
on average, but the frequency may need to be
changed depending on the hardness of the
water.
1 2
MAINTENANCE
DISCONNECT THE ELECTRICAL
POWER SUPPLY, BEFORE
ATTEMPTING ANY WORK
ON THE UNIT.
No need of any particular maintenance.
This unit is fitted with an active carbon filter, and
requires no external venting. This filter has to be
changed every year.
1 3
FAULT FINDING / REMEDIES
For the most past, any inconsistencies in the operation of the unit will be minor and easy
rectified. Please refer to the chart below.
IN ALL CASES, YOU MUST DISCONNECT THE MACERATOR
If the problem cannot be easily remedied in this way, please call our Service organisation.
ALL WORK INVOLVING DISMANTLING OF THE APPLIANCE
MUST BE CARRIED OUT BY AN APPROVED REPAIR AGENT
SYMPTOMS
• The unit stops
• The motor intermittently activates
• The water in the WC pan goes down
very slowly
• The motor operates normally, but
continues to run for a long time
• The motor does not activate
• The motor emits a rattling or
crunching sound, hums, but
does not run
• Cloudy water comes up into the
shower basin (units with side inlets)
1 4
REMOVAL
DISCONNECT THE ELECTRICAL POWER SUPPLY
BEFORE ANY SERVICE
REMOVING THE UNIT FROM THE WC SUITE
Disconnect the electrical power supply,
A
B
Turn off the water feed to the WC cistern. Bail out as much water as possible from the cistern,
C
Remove discharge hose from elbow,
Disconnect any inlet pipes from the unit,
D
E
Unscrew the 2 fastering screws (to the floor) if fitted,
Remove the flexible connector off the WC pan spigot and slide the flexible connector off the WC
F
spigot and slide the unit out from behind the WC.
HINGED SIDE INLET VALVES CLOGGED
Remove the sleeves and use a screwdriver to free or clean the rubber flaps if necessary.
GUARANTEE
1 5
2 years guarantee as from its date of purchase subject to correct installation and correct use.
FROM THE POWER SUPPLY
PROBABLE CAUSES
• An object is blocking the blades
• The unit has been running for too
long
• The connected sanitary devices are
leaking
• The non-return valve is faulty
• The air dispenser is clogged up
• The length or height of the
installation is over the specification,
or there are too many bends/elbows
• The pump cover plate is occluded
• The electrical power supply is not
active
• The plug is defective
• The motor is defective or the control
system
• Foreign object into the box
• Problem with the motor or the
control system
• Shower installed too low as
compared with the macerator unit
• Hinged side inlet discs clogged up
REMEDIES
• Ask an approved repair agent to
intervene
• Check the installation upstream
• Clean or replace the non-return valve
• Clear the air dispenser
• Check the installation
• Otherwise, ask an approved repair
agent to intervene
•Restore the electrical supplyl,
• Repair the plug,
• Call a service engineer to check the
motor
• Otherwise, ask an approved repair
agent to intervene
• Remove the foreign body
(see section
)
1 4
• Otherwise, ask an approved repair
agent to intervene
• Check the installation
• Clean the hinged discs
(see section
)
1 4
• Otherwise, ask an approved repair
agent to intervene
Tabla de contenido
