Tabla de contenido
Idiomas disponibles
Idiomas disponibles
1) General switch
2) Suction motor and detergent switch
3) Brush motor switch
4) Brush and detergent security switch
5) Hours counter (according to models)
1) Solution adjuster lever
2) Recovery tank inspection plug
3) Squeegee lift/lower lever
4) Recovery tank drain hose
5) Solution tank filler
Battery connection diagram
1) Battery compartment
2) Emergency button / temporary interruption
3) Charger connection
4) Battery power indicator
1) Squeegee fixing screw
2) Bolt for squeegee blade replacement
Be careful not to damage the packaging when the
machine is unpacked – it could be used again if the
machine has to be transported over a long distance.
Check the conditions of the machine immediately
and if it has been damaged during the transportation,
immediately notify the transport company.
Electric and with gel battery included machine are
ready to use.
To insert batteries it’s necessary:
Install the batteries in their specific place (Photo D
- 1), carefully checking that they are in perfect
condition.To make the battery connections, the
surfaces they come into contact with have to be
accurately cleaned. It is advisable to apply a fine
layer of grease or Vaseline to the terminals or the
connections. Install and charge the batteries in a
dry ventilated place, far from sources of heat and
corrosive substances. Make sure that the voltage
between the batteries and the battery charger
corresponds. Protect the circuit with a delay switch
or a fuse with a higher charge than the maximum
absorption of the battery charger. Comply with the
polarity of the battery plug. Photo C shows the
14
correct connection of the batteries
We recommend calling the assistance centre or a
technician if you have problems with the setting
given. The machine is equipped to Optima battery
type charter configurated. If the operator desire use
different battery, it’s necessary verify dip switch
position (Photo D - 1-5):
SW1
Battery type
Dip1
OFF
Pb-Acido
Gel
OFF
Optima
OFF
A) WITH INTEGRATED BATTERY-CHARGER.
Use the battery-charger plug on the machine.
B) WITHOUT INTEGRATED BATTERY-CHARGER.
Connect the battery-charger plug to the socket on the
machine.
Before every wash, the solution tank has to be filled
with the correct quantity of water and
detergent. The tank is filled through the special
hatch at the front of the machine. The solution and
recovery tanks are made in polythene, resistant to
acids and basics and to the majority of solvents. To
clean the floor well it is necessary to use a detergent
(
suitable for the surface to be cleaned
and the type of dirt. If necessary, contact the supplier
or a competent person, remembering that a detergent
that is too aggressive can be damaging for the long
life of the machine. It is necessary, therefore, to use
a
detergent or a
prevent the suction motor from being damaged. To
start the wash, turn on the ignition switch of the
brush motor and open the tap to let water come out.
The dose of the water should be such that the
surface to be cleaned is quite wet, without however
causing splashes, trickles or overflow from the
squeegee. The squeegee must be lowered using
the lever when the machine is started up, and the
suction motor must be turned on with the switch on
the control panel. Remember to lift the floor cleaner
before reversing to avoid damaging it. If the floor is
very dirty, it may need to be washed twice. In the
first stage the brush will be lowered, but without the
liquid being sucked by the squeegee. The detergent
solution will be left on the floor for the time necessary
to dissolve the dirt, and then collected when the
machine goes over a second time. This second
stage will be done with the brush lowered and the
SW2
Dip2
Dip1
Dip2
ON
ON
ON
OFF
OFF
ON
OFF
OFF
ON
to
Tabla de contenido
