Important - Astralpool 57186-0100 Manual De Instalación Y Mantenimiento

ADVICE DURING INSTALLATION AND ASSEMBLY OPERATIONS.
During the connection operations of the electrical wiring to the valve modules, great
attention must be given to polarity, and it must be verifi ed that pieces of wiring are not
left inside after closing.
Make all connections by following the instructions in this manual.
It should be verifi ed that the electrical wiring connections to the valves electronic card
are fi rmly made.
The seal on the module's box should be checked for correct positioning to prevent the entry
of water, it should also be checked that the compression gland is also correctly located
Particular attention should be paid, so that, under no circumstances, is it possible for
water to enter the electronic module. In the case where the intended use is not that for
which the valve was designed, adaptation and supplementary technical regulations may
be necessary.
ADVICE FOR WHEN PUTTING INTO SERVICE.
Before putting the automatic valve into service, it is necessary to verify the calibration
of the electrical protection devices in the operations cabinet and that they are correctly
positioned and fi xed in place.
NOTE: It is recommended that the bathing facilities are not used while the fi ltration
equipment is in operation.
ADVICE DURING INSTALLATION AND MAINTENANCE WORK.
National installation regulations must be taken into account when assembling and
installing the automatic valve.
Extra care must be taken so that it is not possible, under any circumstances, for water
to enter the automatic valve electronic circuit.
All contact, including accidental, must be avoided at all times with the moving parts in
the automatic valve during operation and/or before complete shutdown.
Before carrying out any maintenance or any other electrical or electronic work, it must
be ensured that switch-on devices are locked.
It is recommended that the following steps be taken before performing any maintenance
on the automatic valve.
1.- Remove electrical power to the valve.
2.- Lock the switch-on devices.
3.- Verify that there is no electrical power being applied to the circuits, including
auxiliary and supplementary services.
This list must be considered indicative and not binding with respect to safety, there may
be other specifi c safety standards in particular regulations.
IMPORTANT: due to the complexity of the situations covered, the instructions for
installation, use and maintenance contained in this manual, do not make any attempt to
cover all possible service and maintenance cases. If additional instructions are necessary
or specifi c problems arise, please do not hesitate in contacting the distributor or the
valve manufacturer directly.
Our automatic valves may only be installed in swimming or other pools which fully comply
with the HD 384.7.702 standard. When any doubt exists a specialist should be consulted.
Please check the packing contents.
5
ENGLISH