Troubleshooting - HMM Diagnostics smartLAB Manual De Instrucciones

Troubleshooting

Problem
Display will not light
up
LCD is dark / shows
„LO"
+ Err shows
Display shows „E 01"
Display shows „E 02"
Display shows „E 03"
Display shows „E 10"
or „E 11"
Display shows „E 20"
Display shows „E 21"
Display shows „EExx"
Display shows „out"
Cause
Batteries are exhausted
Batteries are inserted incorrectly
AC Adapter is inserted incorrectly Replace the AC adaptor tightly
Battery too weak
Data communication failed
Cuff is not secure
Cuff too tight
The pressure of the cuff is excess Relax for a moment and then measure
The monitor
motion,talking or the pluse is
too poor while measuring.
The measurement process does
not detect the pulse signal.
The treatment of the
measurement failed.
A calibration error occurred. (X
can be some digital symbol, such
as 1, 2,etc., if this similar situa-
tion appear, all belong to
calibration error.)
Out of measurement
range
Remedy
Replaxe with new batteries
Insert the batteries correctly
Insert new batteries
Check if the App/ Bluetooth® is on or not,
then try data transmission again
Refasten the cuff and measure again
Reapply cuff and start the measurement
again
again
detected Movement can affect the measurement.
Relax for a moment and then measure
again.
Loosen the clothing on the arm and then
measure again.
Relax for a moment and
then measure again.
Retake the measurement.If the problem
persists,contact the retailer or our custo-
mer service department for further assis-
tance.Refer to the warranty for contact
information and return instructions.
Relax for a moment. Refasten the cuff
and then measure again. If the problem
persists, contact your physician.
59