Touble Shooting - Sima DEL-32 Manual De Instrucciones Original

13. TOUBLE SHOOTING.

PROBLEM
NOT ENOUGH POWER TO CUT OF BEND.
THE BENDING PLATE DOESN´T RETURN TO ITS
ORIGINAL POSITION AFTER THE BEND IS
COMPLETE
NOT ENOUGH OR UN CURRENT REACHING THE
MACHINE, THE PILOT LIGHT DOESN´T COME ON
THE PILOT LIGHT IS ON BUT THE MACHINE
DOESN´T WORK
230V OR 400V CONNECTION. THE CONNECTION
IS CORRECT BUT THE MACHINE DOESN´T HAVE
ENOUGH POWER.
THE MACHINE LOSES OIL THROUGH THE GEAR
BOX
WHEN BEND IS FINISHED THE PLATE DOESN´T
STOP AT THE ORIGINAL POSITION
THE BENDING PLATE DOESNT STOP IMMEDIATELY
WHEN THE PEDAL IS RELEASED
STRANGE NOISE FROM WITHIN THE GEARBOX
STRANGE NOISE FORM THE MOTOR
POSSIBLE CAUSE
LOOSE OR DAMAGED BELTS
DAMAGED BLADES
MOTOR NOT RECEIVING CORRECT CURRENT
DEFCTIVE INDUCTIVE SENSOR
LACK OF CURRENT REACHING THE ELECTRICAL
JUNCTION BOX
MAIN ELECTRICITY DOWN
FUSE HAS BLOWN ON THE JUNCTION BOX
CABLE IN BAD STATE
THE MACHINE ISN´T CORRECTLY CONNECTED
EMERGENCY STOP BUTTON IS DEPRESSED
SECURITY FEATURES ARE ACTIVATED
UNSTABLE ELECTRICITY SUPPLY
RUBBER WASHER DETERIORATED.
DEFCTIVE INDUCTIVE SENSOR
THE MOTOR BRAKE HAS WORN
THE MOTOR BRAKE IS NOT OPERATIONAL
DETERIORATION OF SOME OF THE INTERNAL
COMPONENTS
MISFUNCITION OF ONE OF ITS COMPONENTS
20
SOLUTION
TIGHTEN OR REPLACE BELTS
REPLACE BLADES OR CHANGE CUTTING SIDE
CHECK VOLTAGE
CHECK THE SENSOR (1 OPEN, 0 CLOSED).
REPLACE IF DAMAGED
CHECK SITE JUNCTION BOX TO MAKE SURE
ELECTRICITY IS BEING PRODUCED
CHECK THE CURRENT FROM THE MAINS
REARM THE FUSE
REPLACE THE CABLES
CHECK THAT ALL PHASES ARE COMPLETE. CHECK
THE FUSE IN THE MACHINES ELECTRICAL BOX
RELEASE EMERGENCY STOP
MAKE SURE ALL DOORS, EMERGENCY
BUTTONS AND PLASTIC TABLE TOP GUARD ARE IN
CORRECT POSITION
CHECK THE ELECTRICITY SUPPLY IF THE VOLTAGE
IS INFERIOR TO 230V OR 400V THE MACHINE
WON´T WORK. A TENSION STABILISER
RECCOMENDED
REPLACE RUBBER WASHER
CHECK THE SENSOR (1 OPEN, 0 CLOSED).
REPLACE IF DAMAGED
CHECK THE MOTOR BRAKE AND TIGHTEN THE
SPRINGS LEAVING A UNIFORM GAP BETWEEN THE
DISC AND THE PLATE OF .3 TO .4MM.
REPLACE THE MOTOR BRAKE
DISMANTLE THE GEARBOX AND CHECK BEARINGS
AND GROOVES. REPLACED DAMAGED ELEMENTS
FIND OUT THE SOURCE OF THE NOISE AND
REPAIR
ENGLISH
STOP
IS