Anexo A: Informações Sobre Compatibilidade Eletromagnética; Guidance And Manufacturer's Declaration- Electromagnetic Emissions - Stryker EOLE DC Powered Support Surface Manual De Operaciones/Mantenimiento

Anexo A: Informações sobre compatibilidade eletromagnética

GUIDANCE AND MANUFACTURER'S DECLARATION- ELECTROMAGNETIC EMISSIONS:

This device is intended for use in the electromagnetic environment specified below. The user of this device
should make sure it is used in such an environment.
Emissions Test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC61000-3-2
Voltage fluctuations / Flicker
emissions
IEC61000-3-3
AVISO
1. The device should not be used adjacent to or stacked with other equipment. If adjacent or stacked use
is necessary, the device should be observed to verify normal operation in the configuration in which it will
be used.
2.Use of accessories, transducers and cables other than those specified or provided by the
manufacturer of this equipment could result in increased electromagnetic emissions or decreased
electromagnetic immunity of this equipment and result in improper operation.
3. Portable RF communications equipment (including peripherals such as antenna cables and external
antennas) should be used no closer than 30 cm (12 inches) to any part of the Pump, including cables
specified by the manufacturer. Otherwise, degradation of the performance of this equipment could result.
www.stryker.com
Compliance Electromagnetic Environment-Guidance
The device uses RF energy only for its internal
Group1
function. Therefore, its RF emissions are very
low and are not likely to cause any interference in
Class B
nearby electronic equipment
Class A
The device is suitable for use in all establishments,
including domestic establishments and those
directly connected to the public low-voltage power
Complies
supply network
836002-5210 V3.8
Voltar ao índice
19