Allmatic XTILUS Serie Manual Del Usuario página 21

7.2 FIXING OF THE FRONT PLATE TO THE GATE
For the fixing of the front plate to the leaf, follow this procedure:
1. Fit the anchor plate onto the piston. Insert the washer, tighten the bolt firmly (Fig. 8).
2. Close the gate.
3. Move the piston with the plate already fitted towards the gate.
4. Move the stem to the limit stop, then move it back by approximately 1 cm and mark the position of the plate.
5. Realize the same operation in opening.
6. If positions correspond, fix the plate on the gate; otherwise revise A and B coordinates (TABLE 1).
N.B.: during the installation, try several times to open and to close the gate, controlling that the gearmotor does not touch the
moving gate
6-1624846 rev. 16
106
TIGHTEN
FIRMLY
13/11/2018
92
62
92
ATTENTION! Lubricate the hole
of the front plate and the towing
of the motor with silicone grease
before the fixing.
Fig. 8
Fig. 7
21 / 52