Product Description - Allmatic XTILUS Serie Manual Del Usuario

GENERAL WARNINGS
ATTENTION! Before installing the product it is mandatory to read the document related to the GENERAL SAFETY
WARNINGS supplied with the product. Document 6-1620001. The supplementary sheet can also be downloaded from www.
allmatic.com.

1. PRODUCT DESCRIPTION

Irreversible gearmotors for wing gates with a leaf length of up to 3,5 metres. The irreversibility of this gearmotor allows you
to avoid using any electric lock for an effective closing of the gate. The motor is protected by an heat probe, that temporary
interrupts the operating cycle in case of prolonged use.
2. TECHNICAL FEATURES
Max. leaf weight
Max. leaf lenght
Power supply
Current absorbed
Motor power
Towing speed
Stem stroke
Gearmotor weight
Capacitor
Daily operations suggested
Max consecutive operations
Service
Unlocking device for emergency
movement
Working temperature
Protection
Average opening time
Max thrust
Control unit
3. CHECKING BEFORE THE INSTALLATION
ATTENTION! THE GATE SHALL MOVE FRICTIONLESS
Note: gate features must be uniformed with the standards and laws in force. The door/gate can be automated only if it is in a
good condition and its conditions comply with the EN 12604 norm.
- The door/gate leaf does not have to have a pedestrian opening. In the opposite case it is necessary to take the appropriate
steps, in accordance with EN 12453 norm, point 5.4.1 (for instance; by preventing the operation of the motor when the
pedestrian opening is opened, by installing a safety microswitch connected with the control panel).
- Must not generate points of entrapment (e.g. between the leaf of the opened gate and the fence).
- No mechanical stop shall be on top of the gate, since mechanical stops are not safe enough.
Note: the leaf must be fixed firmily on the hinges to the pillars, must not be flexible during the movement and must move
without frictions.
WARNING!
• Before to install of motor, it is necessary verify all dimensions and conditions to do it.
• It is recommended to install the mechanical stops on the ground both in opening and closing. If it is not possible to use
them, it is mandatory to use the mechanical stops on the motor, see fig. 10-11 A page 10.
• To optimize the functioning of the automation, we suggest to use the slowing down at the end of the movement
• For installations in places with strong wind, we recommend use of the electric lock type v06, accessory code: 64100182
(electrical lock v06) / 64100183 (half cylinder).
6-1624846 rev. 16
Kg
m
A
W
m/s
mm
Kg
µF
n°
n°
%
°C
IP
s
N
13/11/2018
XTILUS
400
3,5
230V - 50/60Hz
1
200
0,10
400
8,5
12.5
150
20
50
with key
-20...+55
44
20
1600
BIOS2 / BIOS2 ECO
XTILUS 24V
350
3,5
24Vdc
2,5
60
Variable
400
8,5
-
200
45
80
with key
-20...+55
44
14...22
1600
BIOS2 24
15 / 52