Avoiding Radio Interference; Assembling The Accessories; Glass Turntable; Metal Rack - Caso TMG25 MenuTouch Instrucciones De Funcionamiento Originales

•
The device requires an adequate flow of air in order to operate correctly. Leave a
clearance of 20 cm above the oven, 10 cm around the back and 5 cm on both sides.
•
Do not cover up any openings on the device and do not block these off.
•
Do not remove the device's adjustable feet.
•
The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
•
The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they
guarantee the prerequisites for the safe use of this device.
8.9.2

Avoiding radio interference

The device can cause the occurrence of interference in radios, televisions or similar
devices.
Such faults can be rectified or reduced as a result of employing the following measures:
•
Clean the door and the sealing surfaces of the device.
•
Set the radio, the television, etc as far as possible away from the device.
•
Connect the device to a different electrical outlet, so that various power circuits are used
for the device and the receiver with the interference.
•
Use a properly installed antenna for the receiver, to ensure good reception.

8.10 Assembling the accessories

► The device can be operated with glass turntable or with glass turntable and metal rack.

8.10.1 Glass turntable

Assemble the glass turntable as follows:
• Insert the rolling ring
• Insert the glass turntable so the groove on the underneath side of the glass turntable
catch in the drive shaft.
► When operating the grill, the metal rack can also be used in order to grill the food
evenly as a result of the rotation.

8.10.2 Metal rack

• Insert the metal rack onto the glass turntable.
caso TMG25 MenuTouch
Please note
Please note
50