Tabla de contenido
The electrical diagram must be adapted to the installation to be implemented. For more complex installations than those
presented below, please consult the diagrams book available as a pdf.
Note: The door station can control an electric lock or a motorised gate. To control both, a relay module is required, ref.
9020031.
7.1 Installation with an external "1-button" module and a monitor
1
See diagram
at the end of the document.
7.2 Installation with an external "1-button" module and two monitors
Bus line between the two monitors
2
See diagram
at the end of the document.
Bus line distributed via the electric panel
3
See diagram
at the end of the document.
7.3 Installation with an external "2-button" module and two monitors
4
See diagram
at the end of the document.
7.4 Push button for a remote buzzer
It is possible to connect an independent push button enabling the buzzer on the monitors to ring with a different tune
from that used for calls from an external module.
11
Brightness setting thumb-wheel
16
Contrast setting potentiometer
17
Colour setting potentiometer
12
Buzzer level selector
Conversation
13
thumb-wheel
Note: do not alter the setting of the potentiometer to the le of potentiometer 16 (factory setting).
Copyright © 2016 Somfy SAS. All rights reserved.
7 ELECTRICAL DIAGRAM
9020027
9020027
0
0
230V
230V
+BUS-
+BUS-
N L
230 VAC
50 Hz
8 SETTINGS
Front panel
Perform a communication test with the external module. Turn thumb-
wheel 11 and potentiometers 16 and 17 until the image is displayed
correctly.
Perform a buzzer test, adjust the 3-position selector to the position that
suits the users.
volume
setting
Perform a communication test with the external module. Turn the thumb-
wheel until the voice of the person speaking can be heard clearly.
Back of the front panel
16
17
11
12
13
EN
11
Capítulos
Tabla de contenido
