Tabla de contenido
Idiomas disponibles
Idiomas disponibles
POCKET CUTTING
See Figure 23
Always adjust bevel setting to zero before makinga
pocket cut. Attempting a pocket cut at any othersetting
can result in loss of control of the saw,possibly causing
serious injury.
Adjust the bevel setting to zero, set the blade to the correct
blade depth setting, and swing the lower blade guard up
using the lower blade guard handle.
Always raise the lower blade guard with the handle to
avoid serious injury.
While holding the lower blade guard by the handle, firmly
rest the front of the base flat against the workpiece with
the rear of the handle raised so the blade does not touch
the workpiece.
Depress the lock-off button and squeeze the switch trigger
to start the saw. Always let the blade reach full speed then
slowly lower blade into the workpiece until base is flat
against workpiece.
After you complete your cut release the trigger and allow
the blade to come to a complete stop. After the blade has
stopped, remove it from the workpiece. Corners may then
be cleared out with a hand saw or sabre saw.
Never tie the lower blade guard in a raised position.
Leaving the blade exposed could lead to seriousinjury.
English(original instructions)
LOWER BLADE GUARD
LOWER BLADE GUARD
HANDLE
WARNING
WARNING
MAINTENANCE
When
Greenworksreplacement parts. Use of any other parts
maycreate a hazard or cause product damage.
Always wear safety goggles or safety glasses withside
shields during power tool operation or whenblowing
dust. If operation is dusty, also wear adust mask.
To avoid serious personal injury, always removethe
battery pack from the tool when cleaning orperforming
any maintenance.
GENERAL MAINTENANCE
Fig. 23
Avoid using solvents when cleaning plastic parts.
Mostplastics are susceptible to damage from various types
ofcommercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
'R QRW DW DQ\ WLPH OHW EUDNH ÀXLGV JDVROLQHSHWUROHXP
based products, penetrating oils, etc.,come in contact
with plastic parts. Chemicals candamage, weaken or
destroy plastic which mayresult in serious personal
injury.
The parts shown on the parts list are intended to be
repaired by an authorized service center.
EN - 16
WARNING
servicing
use
WARNING
WARNING
WARNING
only
identical
Capítulos
Tabla de contenido
