Adjust The Footplate Angle; Operate The Machine; Maintenance; Clean The Machine - GreenWorks JSD401 Manual Del Operador

3
Soft materials such as wood, plastics, etc.
and when fast cutting is more important
than a clean cut.
7.4

ADJUST THE FOOTPLATE ANGLE

The footplate may be tilted to allow angle cuts up to 45° in
either direction.
1. Switch the trigger to the right.
2. Adjust the angle as needed.
3. Switch the trigger to the original position.
7.5

OPERATE THE MACHINE

For best performance, always select a specified blade for
the particular application and type of material you wish to
cut.
General cutting
1. Put the front of the saw base on the workpiece
NOTE
English
2. Align cutting edge of the blade with the line on your
workpiece
3. Start the saw and move it forward on the work surface.
Plunge cutting
1. Make the line of cut clearly on the workpiece.
2. Set the cutting blade at 0.
3. Put the front of the saw base on the workpiece
4. Use high speed to start the machine and slowly lower the
blade into the workpiece until the blade cuts through the
wood.
To decrease the risk of injury, keep hands away from the
blade and all moving parts. Always wear safety gloves or
glasses with side shields.
8

MAINTENANCE

Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Remove the battery pack from the machine before
maintenance.
8.1

CLEAN THE MACHINE

The machine must be dry. Humidity can cause risks of
electrical shocks.
• Clear the unwanted material out of the air vent with a
vacuum cleaner.
• Do not spray the air vent or put the air vent in solvents.
• Clean the housing and the plastic components with a
moist and soft cloth.
9

TECHNICAL DATA

Voltage
Motor
Length Of Stroke
Strokes Per Minute
Cutting Angle
Orbital Motion
9
WARNING
CAUTION
CAUTION
WARNING
CAUTION
24 V
Brushless
1'' (25.4 mm)
-1
0-3000 min
0-45°
4 settings
EN