Tabla de contenido
Idiomas disponibles
Idiomas disponibles
REPLACING
BATTERY
n_asWARNING:
Do not short battery termi-
by allowing awrench
or any other object
to contact
both terminals
at the same time.
Before
connecting
battery,
remove
metal
bracelets,
wristwatch
bands, rings, etc.
Positive terminaf
must be connected
first to
preventspark=ng
from accidental
grou nding.
1. Lift hood to raised position.
2. Removetermina[
cover.
3. Disconnect
BLACK
battery
cable then
RED battery cable and carefully remove
battery from tractor.
4. I nstalt new battery with terminals in same
position
as old battery.
5. Reinstall
terminal coven
6. First connect
RED battery cable to posi-
tive (+) battery terminal with bolt and nut
as shown. Tighten
securely.
7. Connect
BLACK
grounding
cable
to
negative (-) battery terminal with remain-
ing bolt and nut. Tighten
securely
8. Close hood.
(_-"__
Negative
_.F_ .._
F_. / ._
\_ ...(Black)
__
Cable
Terminal
_
_'.,_--_b,-')
Cover
.
Positive _,
-_"__
(Red)I-
_
_
/7
FRONT WHEEL
TOE-IN/CAMBER
You r new tractor front wheel toe-in and cam-
ber is set at the factory and is normal. The
front wheel toe-in and camber are not adjust-
able. If damage
has occurred
to affect the
factorysetfrontwheeltoe-in
or camber, con-
tact a Sears or other qualified service center.
INTERLOCKS
AND RELAYS
Loose or damaged
wiring
may cause your
tractor to run poorly, stop running, or prevent
it from starting.
• Check wiring.
TO REPLACE
FUSE
Replace with 30 amp automotive-type
plug-
in fuse.
The fuse holder is located
behind
the dash.
TO REPLACE
HEADLIGHT
BULB
1. Raise hood.
2. Remove bulb holder from the hole in the
backside
of the grill.
3. Replace
bulb in holder and install bulb
holder securely
back into the hole in the
backside of the grill.
4. Close hood.
TO REMOVE
HOOD & GRILL ASSEMBLY
1. Raise hood.
2. Unsnap
headlight
wire connector.
3. Stand in front of tractor.
Grasp hood at
sides,
tilt toward
engine
and lift off of
tractor.
4. When replacing
hood, be sure to recon-
nect the headlight
wire connector.
Headlight Wire
nector
)
ENGINE
TO ADJUST THROTTLE CONTROL
CABLE
The throttle control has been preset at
the factory and adjustment should not be
necessary Check adjustment as described
below before loosening cable. If adjustment
is necessary, see engine manual
TO ADJUST CHOKE CONTROL
The choke control has been preset at the
factory and adjustmentshould not be neces-
sary. If adjustment is necessary, see engine
manual.
TO ADJUST
CARBURETOR
Yourcarburetor
has been preset atthe factory
and adjustment
should
not be necessary.
However, minor adjustment
may be required
to compensate
for differences
in fuel, tem-
perature,
altitude or load. ffthe engine does
need adjustment,
see engine manual.
29
Tabla de contenido
