Installation Of The Appliance - TESY HL-222H PTC Instrucciones De Uso Y Mantenimiento

CHARACTERISTICS
EN
Handle

INSTALLATION OF THE APPLIANCE

•
This appliance does not require any special assembly.
•
The air inlets and outlets of the appliance must never
be covered or hampered!
•
The appliance is intended to be used over horizontal
floor! It is forbidden to be mounted on wall or ceiling!
•
You must never place the appliance below socket outlets!
•
The appliance is not suitable to be used in a bathroom.
OPERATION
•
Turn the thermostat switch clockwise (to the right,
starting from position MIN) until it reaches its final
position МАX.
•
Summer service (fan-only air-circulation): turn the
switch to position FAN
•
Heating at reduced power: turn the switch (to the
right) to position LOW (1100W).
•
Heating at full power: turn (to the right) to position
HIGH (1800W).
•
Switching off: turn the switch (to the left) to position
OFF.
Room temperature regulation through the
THERMOSTAT CONTROL KNOB
When the room temperature gets to its desired condition you
should turn the right-hand switch of the heating controller
4
Usage and Storage Instructions
Metal grill
Thermostat
control knob
Main control
knob
Power indicator
Thermostat control
knob
Switch
in counter-clockwise direction to position in which the
appliance turns off but not more than that. The adjusted
that way temperature will be automatically regulated and
kept at a permanent level by the heating controller.
OVERHEAT SAFETY DEVICE
The fan heater is fitted with a safety device that switches
off the heater in the event of accidental overheating
(for example: blockage of air inlet or outlet, slow or no
engine motion). If the heater switches off during normal
operation – at first, check if the appliance is not dirty – if it
is, clean in the way described above, if the heater is clean
– turn to the authorized repair service in your town!
CLEANING
•
Always turn off and unplug the heater from the
mains supply before cleaning.
•
Do not use abrasive cleaning products!
•
Clean the body of the appliance with a damp cloth,
a vacuum cleaner or a brush. Never immerse the
appliance in water - danger to life exists!
•
If the heater will not be in use for a certain period,
it has to be preserved from excessive covering with
dust and dirt by packing into its original box.
•
Never put the appliance into its box when it is warm!
WARNING
•
Do not use the appliance next to shower, bath,
shower room, swimming-pool etc.
•
The appliance always should be used in upright position.
•
Do not use the fan heater for laundry drying. Never
cover the inlet and outlet grating (there is a risk of
overheating). The appliance must be placed at a distance
of minimum 50 cm from furniture and other objects.
•
The appliance must be placed so that its control
switches are not in the hand-range of persons using
bath or shower.
•
Do not use the appliance in rooms smaller than 4
square meters.
Fan heater has in-built safety device that will turn it off
in case of accidental overheating (for example blocking
of the inlet and outlet grating, slow rotation or no
rotation of the motor).
In order to restart the fan heater, you must disconnect
the plug from the socket for a few minutes (10-30).
Remove the cause for the overheating and then turn the
appliance on again.
Warning: in order to prevent
overheating, do not cover the appliance!
Instructions on Environment protection:
Obsolete electric appliances contain valuable
materials and consequently should not be disposed
as domestic waste! We ask you for your cooperation
to protect the natural resources and the environment
by returning the appliance to organized buy-back
stations (if there are such).