Safety Information; Installation; Preparing The Unit Connection - Oase ProfiClear Premium Instrucciones De Uso

3

Safety information

The company OASE has built this unit according to the state of the art and the valid safety regulations.
Despite the above, hazards for persons and assets can emanate from this unit if it is used in an
improper manner or not in accordance with its intended use, or if the safety instructions are ignored.
For safety reasons, children and young persons under 16 years of age as well as persons who
cannot recognise possible danger or who are not familiar with these operating instructions, are
not permitted to use the unit. Keep children under supervision to ensure that they do not play
with the unit.
4

Installation

The following tools are required:
10 mm ring spanner
7 mm socket spanner
PZ3 Phillips screwdriver
Cordless drill/screwdriver with PZ3 bit (do not set to "drill"!)
4.1

Preparing the unit connection

Before installing, connecting and starting up the unit, perform the following tasks:
1 Fit 1× DN 75 slide valve (
2 Fit 2×
2 Fit 2× DN 150 outlets (
2 Fit 2× meshed tubes (
Remove the container cover.
Fitting the DN 75 slide valve
5.
How to proceed:
B
1. Fit the slide valve into the connecting sleeve and secure with a hose clip.
2. Fit the connecting sleeve onto the connection.
3. Secure the holding plate of the slide valve to the outside of the container with cap nuts.
4. Secure the hose clip on the connection.
Fitting the 180 mm inlet
5.
How to proceed:
C
1. If not already done: Fit the sealing ring into the wall of the container from the outside.
Ensure that the raised marking is at the top and aligned in relation to the hole pattern.
2. Fit the inlet to the sealing ring.
Ensure that the raised marking is at the top and aligned in relation to the hole pattern.
3. Fasten the sealing ring and inlet from the inside with oval head screws.
Tighten all screws diagonally using the cordless screwdriver to ensure that the sealing ring is
uniformly applied. Further tighten the screws using a Phillips screwdriver.
4. Fit the rubber sleeve over the inlet and fasten with a hose clip.
Turn the hose clip so that the screw is accessible from the side. This facilitates later installation
work.
A 9)
180 mm inlets ( A 4)
A 7)
A 6)
- GB -
21