V2 City4 Manual De Instrucciones página 41

DISPLAY DATA DESCRIPTION
LP.PA no/Si Flashlight in pause
Strt Operation modes
no - Start inputs from terminal board are disabled
StAn - Standard operation
APCH - Separated opening and closing commands
PrES - Manned operation
oroL - Timer operation
StoP STOP input
no - STOP input not available
- STOP command stops the gate: START command starts
invE
- STOP command stops the gate: pressing the START command
ProS
Foto PHOTO 2 input
CFCh - Photocell is active in closing and also when the gate is still
no - Not available
Ch - Photocell is active during the closing
tESt no / Si Test of safety devices
no - Function not active
Foto - Test enabled only for photocells
CoSt - Test enabled only for safety edges
Ft.Co - Test enabled either for photocells or for safety edges
ShAd Photocell 2 shadow zone
no - Function disabled
F.ShA - Time of end disabling
i.ShA - Time of beginning enabling
CoSt Border input
no - Input disabled (the control unit ignores it)
rESi - Input enabled for conductive rubber ribbons
StAn - Input enabled for standard safety ribbons with normally closed contact
FC.En End of stroke inputs
no - Input disabled (the control unit ignores it)
- Inputs enabled: the gate starts the slowdown phase (menu t.rAL) near
rALL
StoP - Input enabled: the gate stops near the limit switches
t.inA 0 ÷ 8 Max. gate quiescent time
ASM 0.5" ÷ 2.0' Anti-skid
no - Function disabled
SEnS 0 ÷ 10 Obstacle sensor level
Cont Counter viewing
tot. - Total number of completed cycles (views in thousands or in units)
Man - Number of cycles before the next request for service (such a number has
APPr Automatic learning of the operation time
no - Function disabled
Go
- Start up of the automatic learning procedure
FinE End of programming
no - It does not exit from the program menu
Si - It exits from the program menu by storing the setup parameters
City4 FUNCTION TABLE
moving in the opposite direction
gate continues the motion
the limit switches
been rounded off to hundreds and it can be set up on 1000-step; in
case it is set up on 0, the request will be disabled and no will be viewed)
39 39
DEFAULT DEFAULT MEMO
AntE SCor DATA
no no
StAn StAn
no no
CHCh CHCh
no no
no no
no no
no StoP
0 0
1.0" 1.0"
5 5
tot tot
no no
no no