Alliance Laundry Systems SF35PV Manual Del Usaurio página 16

Operation
Using the auxiliary 1 (A1) and auxiliary 2 (A2)
outputs for wet cleaning
The A1 and A2 outputs (so labeled on the solid state
WE-6 output PC board) can be made to operate as
timed outputs, or to remain on until a drain step.
Reduced wash speed
Normally, the A1 output would govern optional
reduced wash speed. This means that if the WE-6 is
prompted for "WET CL", and then an auxiliary 1 "A1"
step is programmed for any amount of time (one
second is a good choice for time in the event of
controlling reduced wash speed), the A1 output will
remain on until a drain step, or until Stop routine.
Thereby the reduced wash speed remains in effect as
long as A1 remains on.
For example, with "WET CL" prompt selected, a
Wash 1 agitation is wanted, but at reduced wash speed.
Program auxiliary 1 step for one second, then program
a Wash 1 step. The A1 output will remain on during
the Wash 1 step, selecting reduced wash speed during
the Wash 1 step. Upon reaching a drain step, or upon
entering the Stop routine, the WE-6 will operate the
machine at reduced wash speed (PROVIDED the
machine is equipped with the necessary hardware for
controlling reduced wash speed).
14
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Control of an optional recirculation pump
The A2 output will also remain on until a drain or the
Stop routine if the WE-6 prompt is "WET CL" and if
"1DRAIN" is selected. This would allow control of an
optional recirculation pump by permitting the pump to
continue operating during a wash step. For this
control, program an auxiliary 2 "A2" step for one
second or other suitable time, and the output would
remain on until a drain step or until the Stop routine.
The auxiliary 2 step would also go off upon entering a
Wash 7 step.
Note that "2DRAIN" prompt will OVERRIDE wet
clean control of auxiliary 2 output. If "2DRAIN" is
selected that means that the auxiliary 2 output is
reserved for controlling a second independent drain
(not for integrated reuse – you should select
"1DRAIN" for integrated reuse). Also, if "2DRAIN"
is selected. the WE-6 will not permit programming an
auxiliary 2 step.
F232059