Setting Up The Transmitter - Medtronic MiniLink Manual De Usuario

MP6025647-21A3 / A
the charging time will be less than 20 minutes. A fully charged transmitter battery
works more than 14 days without recharging. After 14 days of use, the transmitter
recharges in less than two hours.
To charge the transmitter:
1 If a green light on the transmitter is lit or flashing, do not
connect it to the charger. The transmitter will not charge
with its green light on. Wait until the green light turns off
(approximately 30 seconds), and then connect the
transmitter to the charger.
2 Connect the transmitter to the charger by lining it up, flat
side down, with the charger. Push the two components
together fully.
3 Within 10 seconds after the transmitter is connected, a
green light on the charger will flash for 1 to 2 seconds as
the charger powers on. For the rest of the charging time,
the charger's green light will continue to flash in a pattern of
four flashes with a pause between the four flashes.
4 When charging is complete, the green light on the charger
will stay on, without flashing, for 15 to 20 seconds and then
turn off.
5 After the green charger light turns off, disconnect the transmitter from the
charger. The green light on the transmitter will flash for about 5 seconds and then
turn off.

Setting up the transmitter

For instructions on setting up your transmitter, see the user guide for your pump.
Connecting the transmitter to the sensor
After you have confirmed that the insertion site is not bleeding, connect the
transmitter to the sensor.
Note: The transmitter must be fully charged before connecting it to the sensor.
Before physically connecting your transmitter to your sensor, consult the user guide
for your pump or monitor for details on setting up and starting the sensor.
-5-