Medtronic MiniLink Manual De Usuario página 8

MP6025647-21A3 / A
• If bleeding persists after three minutes, remove the sensor and discard. Insert a new
sensor in a different location.
Contact your local help line or representative for assistance if you experience any
adverse reactions associated with the transmitter or sensor.
Exposure to magnetic fields and radiation
If you are going to have an X-ray, MRI, diathermy treatment, CT scan, or other type of
exposure to radiation, take off your sensor and transmitter before entering a room
containing any of these equipment. The magnetic fields and radiation in the immediate
vicinity of these devices can make the transmitter non-functional. If your transmitter is
inadvertently exposed to a magnetic field, discontinue use and contact your local help
line or representative for further assistance.
Airport security
Important information about airport security systems, and using your transmitter on an
airplane, can be found on the Emergency Card. Be sure to carry the Emergency Card
provided when you are traveling.
Precautions
Establish a rotation schedule for choosing new sensor sites. Avoid sites that are
constrained by clothing, have scar tissue, or are subject to rigorous movement during
exercise.
Notice
This device complies with the United States Federal Communications Commission (FCC)
and international standards for electromagnetic compatibility.
This device complies with Part 15 Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesirable
operation.
The transmitter does not interfere with any radio frequency signals transmitted from
outside sources. These FCC standards are designed to provide reasonable protection
against excessive radio frequency interference and prevent undesirable operation of the
device from unwanted electromagnetic interference.
Important: Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
-2-