Troubleshooting; Accessories - Metabo ASR 35 L AutoClean Manual Original

ENGLISH
ENG
10.5 Water sensor
Clean the water sensor regularly
and check it for signs of damage.
10.6 Technical Inspection for
ASR 35 M AutoClean
At least once a year, the manufacturer or a suitably
qualified and trained person must carry out a dust
test, e.g. to check for damage to the filter, verify
that the appliance is air-tight and that the control
unit is functioning correctly.
For maintenance by the user, the vacuum cleaner
must be taken apart, cleaned and maintained, to
the extent possible, without endangering mainte-
nance staff or other people.
Preventive Measures
Appropriate preventive measures include:
cleaning the appliance before disassembly;
providing local filtered forced ventilation where the
vacuum cleaner is disassembled; cleaning of the
maintenance area and providing suitable personal
protective clothing and equipment.
When carrying out maintenance or repairs, it is
essential to dispose of any contaminated objects that cannot be adequately cleaned. These objects
must be disposed of using impermeable bags and
in accordance with the applicable regulations for
removing such waste.

11 Troubleshooting

If the volume flow control display (3) lights up or if
an acoustic signal is sounded (ASR 35 M Auto-
Clean only), this indicates that the paper filter bag/
fleece filter bag must be emptied.
Reduction in suction power:
See the instructions in the section on Cleaning.
• Filter cassettes (18) soiled? Clean the cassettes.
• Paper filter bag (8)/fleece filter bag (7) full?
Replace the filter bag.
• PE filter bag (6) full? Replace the filter bag.
• Container (11) full? Empty the container.
• Motor protection filter (17) clogged? - See
section 10.
• Nozzle, tubes or hose blocked? Clean.
Appliance will not start:
• Is the plug in the plug socket?
• No power from mains?
• Mains lead OK?
• Appliance hood correctly closed?
• Has the water sensor cut off? - Empty the
container; then switch on and off again.
• Switch (2) in "AR" position? - Set to "I" or "IR".
See section 7.1.
20
• The vacuum cleaner is not switched on or off by
means of a power tool, even though switch (2) is
set to the "AR" position. - Connect the power
tool to the plug socket (4).
Dust in the container when paper filter bag/
fleece filter bag is fitted:
• The position of the rotary slide is incorrect. See
section 6.2.
PE filter bag is sucked against the filter
cassettes (18) :
• The position of the rotary slide is incorrect. See
section 6.3.
PE filter bag is sucked against the filter
cassettes (18) :
• The position of the rotary slide is incorrect. See
section 6.3.
Do not interfere with the appliance.
Contact an authorized workshop or
Metabo's after-sales service department (see
section on 13 Repairs).
f

12 Accessories

Use only genuine Metabo accessories.
If you need any accessories, check with your
dealer.
See page 4.
ASR 35 L AutoClean and ASR 35 M AutoClean:
19 Paper filter bags-M
5 bags = 1 set
20 Fleece filter bags-M
5 bags = 1 set
21 PE filter bags-M
5 bags = 1 set
22 Filter cartridge-M cellulose material
2 pieces = 1 set
23 Filter cartridge-M polyester material
2 cartridges = 1 set
24 HEPA filter cartridge
2 pieces = 1 set
25 Motor protection filter (1 filter) You must order
2 items.
26 Handle
27 Cable clips (10 clips)
28 Suction hose
29 Connecting piece
30 Suction tubes (2 items)
31 Intermediate piece
32 Suction nozzle
33 Floor nozzle (metal fitting)
34 Universal nozzle
35 Universal brush
36 Upholstery brush
37 Crevice nozzle
38 Rubber nozzle