Remote Monitoring - DELTA DORE TTRTC TYXAL+ Manual De Instalación

7. Personalising the transmitter

7.4 Remote monitoring

This menu is used to configure the settings for the remote monitoring. A detailed description of the remote
monitoring settings is available in § Remote monitoring appendix
Ê Enter the installer code (123456, by default) and confirm with OK.
Ë Press Settings, then select the menu:
Installation > Products > Configure
Ì Press the button of the transmitter or select it from the
list of products by clicking on "Browse".
Í Select the "Remote monitoring" menu.
Î Protocol selection
You can choose from the following:
- No, Contact ID P10 to P13, CESA 200 P0 to P2
If the CESA protocol is selected, you can change the
pre-programmed loop numbers:
(see § Personalising the transmitter's operation)
Main number
Specify the main number supplied
by the remote monitoring operator.
Emergency number
Specify the backup number supplied by the
remote monitoring operator.
Identifier
Specify the identifier supplied
by the remote monitoring operator.
Cyclic test
The cyclic test is done at regular intervals.
These intervals are programmed:
- either in number of 1/2 hours,
- or for a specific timetable (1 test/24h).
PSTN transmitter
Remote monitoring
Incoming calls
Auto attendant
Return
Protocol selection
No >
Protocol selection
Return
No
Return
Main number
0
Return
Emergency number
0
Return
Identifier
0
Return
Cyclic test
< 1/2 hour
Number of 1/2 hour
Return
0
Return
58
Remote monitoring
Protocol selection
Main number
Emergency number
Ok Return
Identifier
Cyclic test
Programming
loop?
Loop list
No
Ok
Intruder alarm
Tamper alarm
>
Technical defect
Loop number
Return
Ok
0
Return
Ok
Ok
Ok
Cyclic test
Hourly
Hourly
Ok Return
12.00
Return
Ok
Ok
Yes
Ok
Ok
>
Ok
Ok